RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: ZdenekJindra
Showing results 1 to 7 of 7
Search took 0.31 seconds.
10-18-2008, 01:06 PM
Replies: 11
Views: 1,275
Posted By ZdenekJindra

RE: Difficulty trimming for yaw with a CX2.

I had the same issue, but I solved it by modding the transmitter and adding an extra variable resistor pot to the rudder potentiometer. I tuned it so that the yaw is correct with the outside trim at...
10-18-2008, 12:32 PM
Replies: 6
Views: 756
Posted By ZdenekJindra

RE: Best folding blades for CX/2

I hate to be the critic, but said rcrivesud is complained about for poor customer care. So I think it's decided.
10-18-2008, 12:15 PM
Replies: 11,215
Views: 629,381
Posted By ZdenekJindra

RE: Struggling with Single Rotor basics

My bet is on interference. Placing the motor wires far away from the antenna may help, make sure you are not flying near walls and similar solid obstacles. These can shoot you down even if you are 5...
02-14-2008, 04:25 PM
Replies: 19
Views: 1,478
Posted By ZdenekJindra

RE: I Never Should Have Changed A Thing on my CX2...Please Help.

I'm not sure if it hasn't been answered above, but the problem I see in the video occurs when the motors are connected instead of one another. The blades will move correctly with this setup, however,...
02-13-2008, 05:05 AM
Replies: 18
Views: 1,293
Posted By ZdenekJindra

RE: Is this a bad thing?

With such many coils, the helicopter won't fall if one fails and I bet that the black winding is already out of work. I'd personally change the motor right away.
02-10-2008, 01:40 PM
Replies: 9
Views: 794
Posted By ZdenekJindra

RE: Using 11.1V LiPo's in a 7.4V bird?

I'm not really sure if this is an attempt to start a quarrel. The motors are modulated with PWM which means constant power achieved by narrower pulses with higher voltage. Even if your statement was...
02-10-2008, 05:53 AM
Replies: 9
Views: 794
Posted By ZdenekJindra

RE: Using 11.1V LiPo's in a 7.4V bird?

I regularly use the 3-cell 11.1V battery in my Blade CX and it works great. I have never burnt anything. The differences are:
Much more power upwards, better avoiding of fall if I forget to give it...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.