RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: hydro_gin
Showing results 1 to 25 of 44
Search took 0.72 seconds.
Forum: Futaba Radios Direct support forum
12-14-2006, 03:33 PM
Replies: 2
Views: 554
Posted By hydro_gin

RE: S3155 Dimensions

Thanks for your prompt reply Krysta. The dimensions look good!


Lance
Forum: Futaba Radios Direct support forum
12-14-2006, 01:45 PM
Replies: 2
Views: 554
Posted By hydro_gin

S3155 Dimensions

Hi,

There is conflicting information on the dimensions of the new S3155 digital servo. One site says they are 10.0 mm x 29 mm x 30 mm but another says they are 10.8 mm x 29 mm x 30 mm....
Forum: JR Radio & Spektrum Radios
02-08-2006, 11:39 PM
Replies: 8
Views: 975
Posted By hydro_gin

RE: Does 9303 have a back up?

Mic,

See the Tx Maintenance question a few lines below this one! Danny recommends about a year between servicing when the Tx is frequently used.


Lance
Forum: JR Radio & Spektrum Radios
02-08-2006, 02:57 PM
Replies: 3
Views: 731
Posted By hydro_gin

RE: New BB Version for DS368?

Danny,

Will the DS368BB eventually replace the DS368, or will both continue to be offered?


Lance
Forum: JR Radio & Spektrum Radios
02-08-2006, 04:35 AM
Replies: 3
Views: 731
Posted By hydro_gin

New BB Version for DS368?

I've often heard that the DS368, as awesome a servo as it is, doesn't use ball bearings. However, I just bumped into this at Horizon's website:

...
Forum: JR Radio & Spektrum Radios
11-22-2005, 02:25 PM
Replies: 3
Views: 545
Posted By hydro_gin

RE: DS 168 @6.0V?

Good news!

I forgot to ask, can a DS368 also be run at 6V?


Thanks,

Lance
Forum: JR Radio & Spektrum Radios
11-22-2005, 01:27 AM
Replies: 3
Views: 545
Posted By hydro_gin

DS 168 @6.0V?

I'd like to use some thin DS168's in a sailplane wing. Can they be run safely using a 5-cell 6V receiver pack, or will they need to be run with a 4-cell 4.8V battery? I went to the www.jrradios.com...
Forum: Futaba Radios Direct support forum
10-24-2005, 06:02 PM
Replies: 2
Views: 1,647
Posted By hydro_gin

RE: Futaba S3150 Slim Servo

Thanks for your prompt reply Bill.

I think the S3150 could be a great alternative to servos like the Hitec HS-125MG for thin wing apps. I'll give them a try, but wish it could run them at 6V for...
Forum: Futaba Radios Direct support forum
10-22-2005, 03:37 PM
Replies: 2
Views: 1,647
Posted By hydro_gin

Futaba S3150 Slim Servo

Hello,

Is it possible to run the S3150 using a 6.0V battery pack with or without a regulator?

At the Futaba website, the 6.0V data for this servo is "N/A".


Thanks,

Lance
Forum: JR Radio & Spektrum Radios
04-25-2005, 02:01 AM
Replies: 7
Views: 1,417
Posted By hydro_gin

RE: New JR 72Mhz Synth Module

Should be able to use your existing Rx so long as it has a crystal that corresponds to the frequency you've selected on the Tx synth module. Of course, the ultimate in flexibility would be to use a...
Forum: JR Radio & Spektrum Radios
04-04-2005, 12:52 AM
Replies: 2
Views: 665
Posted By hydro_gin

RE: 9303 tx

I've found that the polymer screen protectors for PDA's and digital cameras work well for protecting my 9303's LCD display. Palm and Fellows among others, sell them. Cut to size to fit. Since the...
Forum: JR Radio & Spektrum Radios
04-03-2005, 10:09 PM
Replies: 7
Views: 1,417
Posted By hydro_gin

RE: New JR 72Mhz Synth Module

I was the interpreting the decription the same way as you, MM, but the wording left open the other possibility.

I've never seen any JR Tx's other than 8103's and 9303's so I don't know why other...
Forum: JR Radio & Spektrum Radios
04-03-2005, 07:18 PM
Replies: 1
Views: 474
Posted By hydro_gin

RE: XP8103 Base Loaded Antenna

I recently got a Becker antenna for my 9303 (haven't installed it yet, soon) but it uses the same JR adaptor that the JR whip requires. Remove the antenna from your Tx, then screw in the adaptor in...
Forum: JR Radio & Spektrum Radios
04-03-2005, 02:51 PM
Replies: 7
Views: 1,417
Posted By hydro_gin

New JR 72Mhz Synth Module

Horizon Hobby has this link up for a new synth module:

http://www.horizonhobby.com/Shop/ByCategory/Product/Default.aspx?ProdID=JRPTXMS

The descriptions says:

- Synthesized Tx Module...
Forum: RC Gliders, Sailplanes and Slope Soaring
02-26-2005, 03:14 PM
Replies: 3
Views: 4,415
Posted By hydro_gin

RE: Valenta model Fredy v-tail glider

For 60" slopers with flaps, you could check out the Munzar Bird (Czech Republic) or CCM Scorpion II (France). Both are distributed in the US at this website:

...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-13-2004, 08:12 PM
Replies: 14
Views: 3,157
Posted By hydro_gin

RE: Where to find multiple servo connectors?

I found out this weekend that greathobbies.com in Canada also carries the Multiplex 6-pin connectors. Bob Breaux at soaringusa.com is a great guy to do business with. I've never made a small order...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-11-2004, 01:11 PM
Replies: 14
Views: 3,157
Posted By hydro_gin

RE: Where to find multiple servo connectors?

Joe makes a great point about the wire gauge, and MPI has a great selection of connectors and wiring accessories. According to MPI, the 20ga can handle 10A continuously. Not sure what their criteria...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-11-2004, 02:54 AM
Replies: 14
Views: 3,157
Posted By hydro_gin

RE: Where to find multiple servo connectors?

Chris is asking for a wiring harness. Among the sailplane folks I hang out with, we build them ourselves using a 6-pin connector from Multiplex (has a green shell). 4 pins for the servo signals and...
Forum: JR Radio & Spektrum Radios
10-15-2004, 02:09 AM
Replies: 79
Views: 11,107
Posted By hydro_gin

RE: JR 9X = 9303

John Derstine has written up a nice review of the 9303 for sailplane enthusiasts here:

http://www.scalesoaring.net/EMM/9303.htm


Lance
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-13-2004, 01:34 AM
Replies: 16
Views: 1,551
Posted By hydro_gin

RE: Finally!! 8U/9C synthetic module due out..

Sigh ... I'd like to point out again that according to Peter Berg, this problem is not limited to use with a Hitec Spectra module. If you read the references I posted, he implies the non-standard PPM...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-09-2004, 02:33 AM
Replies: 16
Views: 1,551
Posted By hydro_gin

RE: Finally!! 8U/9C synthetic module due out..

Oh, as an addendum, Peter Berg mentions in the second post of the thread I previously posted that the Tx bug also occurs in "high end" Futaba Tx's with a Futaba synth module. I can only assume he is...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-09-2004, 01:04 AM
Replies: 16
Views: 1,551
Posted By hydro_gin

RE: Finally!! 8U/9C synthetic module due out..

Read my original post again. I never said or implied there is or will be a problem with any Futaba module.

The one and only point of my original post is ... I am trying to point out to potential...
Forum: JR Radio & Spektrum Radios
10-08-2004, 11:47 PM
Replies: 2
Views: 1,025
Posted By hydro_gin

RE: 9303 switch labels

Hi Rob,

I heard about your switching of the switches over at rcgroups.com. Very creative.

If it were me, I would probably make some labels on my PC using Microsoft Word and print it out on...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-08-2004, 05:19 PM
Replies: 20
Views: 7,800
Posted By hydro_gin

RE: Graupner MX-22

I'd be interested to know what frequency bands are used down under for model aircraft? Is 72Mhz one of them?

Thanks,

Lance
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-08-2004, 02:50 AM
Replies: 16
Views: 1,551
Posted By hydro_gin

RE: Finally!! 8U/9C synthetic module due out..

I'm sure many 9C owners will welcome the synth module.

But if you have any Berg or FMA DSP-based receivers, make sure you find out if the Futaba Tx bug that causes them to transmit a...
Showing results 1 to 25 of 44
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.