RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: doc-b
Showing results 1 to 25 of 39
Search took 0.66 seconds.
Forum: Flybarless Helicopters
12-05-2011, 04:48 PM
Replies: 0
Views: 687
Posted By doc-b

SK-720 & Trex 600N

I just ordered the Skookum 720 for my 600 N . Does anyone have one on there 600 N and how good does it perform
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-19-2005, 01:59 PM
Replies: 6
Views: 1,040
Posted By doc-b

RE: TT 39 Engine

Heck, that is a great warranty. Well I emailed ThunderTiger and just waiting for a reply . Thanks for the Info.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-18-2005, 07:17 AM
Replies: 6
Views: 1,040
Posted By doc-b

RE: TT 39 Engine

Thank You Very Much , I will give it a try
Forum: Helicopters - Full Scale
02-18-2005, 05:26 AM
Replies: 8
Views: 6,811
Posted By doc-b

More Pics of PHI Heli

These are some that I work on. Much Easier to keep flying than the RC, ha ha
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-18-2005, 05:13 AM
Replies: 6
Views: 1,040
Posted By doc-b

RE: TT 39 Engine

Its Probably just over a year old, but I dont remember where I bought it. I would have to look for my reciept. Do you know how long the warranty is ?
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-17-2005, 10:01 PM
Replies: 6
Views: 1,040
Posted By doc-b

TT 39 Engine

I just broke a piece of the piston on my TT 39 Engine, Is it very hard to change and is it worth the trouble. The head has a small ding in it , but the cylinder wall looks good.
Forum: RC Helicopter Beginners Forum
08-09-2004, 03:31 PM
Replies: 3
Views: 2,389
Posted By doc-b

looking fo Reflex Interface Cable

My interface cable for my reflex simulator is not working all the time. seems to be shorting out at times. where can I buy a cable in the U.S. I have been doing a search but not having any luck ...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-16-2004, 01:20 PM
Replies: 3
Views: 988
Posted By doc-b

RE: TT 39 settings

Thanks very much
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-16-2004, 05:11 AM
Replies: 3
Views: 988
Posted By doc-b

TT 39 settings

I have a TT 39 , it runs hot or wah wah I did a lot of reading about engine settings. I set it to factory. 2 1/8 low and 3 on high I have made small adjustments ,but I cant get the temp low...
Forum: RC Helicopter Beginners Forum
04-02-2004, 05:40 AM
Replies: 20
Views: 2,376
Posted By doc-b

RE: The usual Newbie Question

I started out with a picolo, never could fly it. I then bought a nexus 30, I found that the plastic links and balls would wear out very fast. I am now flying a Raptor.
However a friend of mine...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
03-24-2004, 02:13 AM
Replies: 1
Views: 702
Posted By doc-b

flap dampers

I saw on this site for raptor 30 upgrades ,

70 DUROMETER FLAP DAMPER &

80 DUROMETER FLAP DAMPER , What do they do different than the original dampers?

Thanks in advance for the...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-02-2004, 09:32 AM
Replies: 5
Views: 1,118
Posted By doc-b

RE: Raptor 30 ,Tail Rotor Belt

Thank you Woofdog, This clears up everything, My tail rotor and belt was installed wrong, according to this picture. This is probably why I crashed the second time.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-01-2004, 10:44 PM
Replies: 5
Views: 1,118
Posted By doc-b

Raptor 30 ,Tail Rotor Belt

Does it really matter which way the belt is twisted ,.on to the main gear. as long as the tailrotor blade turns up into the main rotor blade rotor wash. Am I correct in assuming this?

The...
Forum: Glow Engines
08-06-2003, 06:10 AM
Replies: 0
Views: 534
Posted By doc-b

TT 36 broken carb

my throttle arm was coming out of my carb. I tried to disassemble it. I tried taking the large nut that appears to be threaded into carb for the high speed needle. It backed out a short distance,...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
07-05-2003, 12:44 PM
Replies: 4
Views: 571
Posted By doc-b

Help with the TT36 I cant tune

yea I have my low end needle set at about 1 3/4 open and the high end 2 1/2 turns open and it runs great. try the settings and if it doesnt run good, just adjust the low end needle slightly
Forum: RC Helicopter General Discussions
05-26-2003, 04:46 PM
Replies: 11
Views: 1,144
Posted By doc-b

Nexus Starter Shaft Problem

Well I fill directly to tank. Is it possible to flood engine, by filling the way I am doing
Forum: RC Helicopter Beginners Forum
05-26-2003, 06:15 AM
Replies: 39
Views: 4,705
Posted By doc-b

Im finished with FMA Copilot

Well I learned how to hover with the copilot., Pedal turns, High hovers.
I am now in fwd flight, flying lazy 8, and large circles, without the COPILOT. It was a great help in learning, sinse I had...
Forum: RC Helicopter General Discussions
05-26-2003, 05:56 AM
Replies: 11
Views: 1,144
Posted By doc-b

Nexus Starter Shaft Problem

I have a nexus 30.
The Pin at the lower part of the starter shaft, near the clutch, keeps shearing. It shears after about every 10 starts. Help please :confused:
Forum: O.S. Engines Support
04-29-2003, 07:51 AM
Replies: 2
Views: 486
Posted By doc-b

os.32 low power

thanks for the info, I am listening to you, and will try it. Thanks
Forum: O.S. Engines Support
04-24-2003, 12:24 AM
Replies: 2
Views: 486
Posted By doc-b

os.32 low power

I have an os.32 on a helicopter. It only has 3 gallons of fuel burned. It takes about half throttle to hover, which is correct. After anbout 15 min of flying, it starts losing power. It then takes...
Forum: Kyosho Helicopters
04-18-2003, 12:34 AM
Replies: 3
Views: 924
Posted By doc-b

but !!!!

but, does anyone know for sure that 550 blades cannot be used?
If they can be used what effect does it have on the performance of the nexus 30 (stock) ?
Forum: RC Helicopter Beginners Forum
04-11-2003, 02:47 AM
Replies: 39
Views: 4,705
Posted By doc-b

Comment on FMA Copilot

well I dont know who came up with the circular Bubble Level idea?
But I just bought one and secured it to the top of the sensor. It worked absolutely great. It takes the guess work out of...
Forum: RC Helicopter Beginners Forum
04-07-2003, 12:23 AM
Replies: 17
Views: 1,136
Posted By doc-b

co pilot help

yes you maybe right, but try it and see if that might work .. Let me know what happens. I have a simular problem. But I cant resolve it until the winds die down. If you still have problems try...
Forum: RC Helicopter Beginners Forum
04-06-2003, 05:27 PM
Replies: 17
Views: 1,136
Posted By doc-b

co pilot help

put the helicopter on its side, level the helicopter with a bubble level. Then push the red button, and release the button. ( Hold the helicopter steady while doing this.) The servos should cyle at...
Forum: RC Helicopter Beginners Forum
04-06-2003, 02:02 AM
Replies: 39
Views: 4,705
Posted By doc-b

Comment on FMA Copilot

yes you are correct
Showing results 1 to 25 of 39
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.