RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Hawkeye438
Showing results 1 to 18 of 18
Search took 0.63 seconds.
Forum: Gas Engines
06-24-2008, 01:49 AM
Replies: 397
Views: 50,380
Posted By Hawkeye438

RE: *Brillelli 26-SSR*

Scott, I ordered a 26cc 3 months ago. I can,t get you on the phone and your e-mail dosen't go through. I need the engine or a refund.
Forum: OMP - Ohio Model Products Support Forum
01-22-2008, 10:37 AM
Replies: 15
Views: 2,117
Posted By Hawkeye438

RE: 65" Yak flight report

I have the exact same setup. Using the Saito 125 and a 17-4 prop. I maidened it Sunday. Knife edge with no coupleling. Hover at 1/3 throttle. Elevator, waterfall very stable. It does Lomchevac and...
Forum: ARF or RTF
07-03-2006, 09:01 AM
Replies: 72
Views: 14,814
Posted By Hawkeye438

RE: Pacific Aero Models Gee Bee Y ARF

Hi guys just to add my 2 cents. I got my 82" 3 weeks ago. I built it with minimal problems, except the pushrods were too short and I replaced with 4-40. For power I used a Saito 182 twin. No added...
Forum: Tips & Techniques
03-02-2006, 10:42 AM
Replies: 9
Views: 1,067
Posted By Hawkeye438

Tachometers

My old (2yrs) tachometer is acting funny and I wondered if anyone has an oponion about what brand I should get for a reliable new one. I could not find any info in the threads. Thanks
Forum: Glow Engines
12-02-2005, 04:53 PM
Replies: 54,893
Views: 5,437,844
Posted By Hawkeye438

RE: Welcome to Club SAITO !

Hi guys, great forum, I just found it. I need to be a member. I have a 56, 82, 3 100, 150, 2 180's and I am interested in the twins and radial. The problem is info from Horizon is minimal. Where can...
Forum: Tips & Techniques
08-25-2005, 02:16 PM
Replies: 5
Views: 1,129
Posted By Hawkeye438

RE: Stretchy Tape for Sealing Surfaces

Duct tape makes a new clear version that is fabulous. Sticks very well.
Forum: ARF or RTF
05-20-2005, 01:42 PM
Replies: 11
Views: 1,161
Posted By Hawkeye438

RE: Anyone have experience with the TT Tiger Bipe 40?

Hey, I am on my second one of these. It is great with an OS 46 or 52FS. I put the switch looking up at the back of the cockpit. also be sure to put lock tight on the bottom wing bolts, they will...
Forum: Futaba Radios Direct support forum
06-21-2004, 11:08 AM
Replies: 2
Views: 533
Posted By Hawkeye438

Hits

I have a Futabe 9C 10 mos old. I have had 4 "hits" resulting in crashes 4 times. I am on ch 56, our club is very strict about frequency control, I don't think the problem comes from inside the club....
Forum: Profile and Fun Flying Planes
12-08-2003, 05:59 PM
Replies: 1
Views: 830
Posted By Hawkeye438

Gee Bee Bipe

Does anyone know who makes, and who sells Gee Bee Bipes? Thanks, Hawkeye
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-21-2003, 07:58 AM
Replies: 1
Views: 418
Posted By Hawkeye438

Help, 9C won't take my info

I have a new in the box 9C Futaba Tx. I put in plane #1 and name, reversed servos for rudder and elevator, worked with it a while, and turned it off. Plugged in for overnite charge, next day I tunred...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-20-2003, 09:52 AM
Replies: 6
Views: 971
Posted By Hawkeye438

RE: basic receiver set up

Thanks, I'll try that.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-20-2003, 04:24 AM
Replies: 6
Views: 971
Posted By Hawkeye438

RE: basic receiver set up

Thanks. Then there must be a mistake in the manuel. I finally found what it said, and it put "aileron" in #5. When I started the basic set up for 4 CH, it then sent me to aileron menu and said...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-19-2003, 08:16 AM
Replies: 6
Views: 971
Posted By Hawkeye438

RE: basic receiver set up

Futaba 9c. Thx.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-19-2003, 03:15 AM
Replies: 6
Views: 971
Posted By Hawkeye438

basic receiver set up

Is there a standard for connecting each type servo to a particular receiver channel? Is the throttle always a certain channel?Etc.
Forum: Questions and Answers
09-03-2003, 12:38 AM
Replies: 5
Views: 693
Posted By Hawkeye438

stand

That will be great, I'll build that one first. Thanx, H
Forum: Questions and Answers
09-03-2003, 12:32 AM
Replies: 5
Views: 693
Posted By Hawkeye438

stands

Thanx, that should help.
Forum: Questions and Answers
09-02-2003, 09:11 PM
Replies: 5
Views: 693
Posted By Hawkeye438

stand

Is there a place to get plans and a cut list to build a stand for my plane? Thanks.
Forum: The Clubhouse
09-02-2003, 08:56 PM
Replies: 0
Views: 399
Posted By Hawkeye438

Plans

Where can I get plans,and parts&cut list ,for a stand for my plane?
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.