RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: renwick56
Showing results 1 to 23 of 23
Search took 0.63 seconds.
Forum: Classic RC Pattern Flying
08-20-2009, 09:37 AM
Replies: 118
Views: 27,692
Posted By renwick56

RE: Tower Kaos 40 – Discussion

Nice job with your Kaos. I just got one. I am going to copy your modifications, except that mine will be electric :) . I am also going to move the empennage servos to the tail.

Cheers
Forum: JR Radio & Spektrum Radios
04-21-2009, 07:02 PM
Replies: 25
Views: 6,938
Posted By renwick56

RE: dx7 and ultra stick

Have i done something wrong???

The GEAR (retract) switch is still working when I use this setup.
Forum: TEAM RCU - Mike McConville
03-10-2008, 10:07 AM
Replies: 2
Views: 1,152
Posted By renwick56

Dangerous Stall in Showtime 90

Hello Mike -

I have a ST 90, that I am having a problem with. My ST will stall abruptly when I pull (or push) elevator, at differing attitudes and slower speeds. For example, it will do this...
Forum: Quiques Aircraft Support - CLOSED
01-14-2008, 09:24 AM
Replies: 5
Views: 711
Posted By renwick56

RE: QQ 69" - is it good to go now?

Has anyone built this out as an electric yet?
Forum: Electric Pattern Aircraft
11-01-2007, 12:38 PM
Replies: 36
Views: 9,520
Posted By renwick56

RE: A123 Cells

Brenner -

Would it be possible for you to post or send me your spreadsheets? I am very interested in them.

Thanks,
Ren
Forum: Batteries & Chargers
10-27-2007, 09:34 PM
Replies: 16
Views: 2,189
Posted By renwick56

RE: First time A123 battery RX pack

Just a note: I built and am using two 2s A123 receiver packs. Before flying with them, I discharge/tested them by monitoring their voltage, an plotting their discharge curves. I used a 10 ohm - 10...
Forum: Batteries & Chargers
10-09-2007, 05:10 PM
Replies: 7
Views: 3,049
Posted By renwick56

RE: Receiver battery ??

Dick -

How do you charge your A123 receiver packs? I intend on using these cells to power my receiver in a plane that will have 6 digital servos. I am doing this as I fear the horror stories...
Forum: ARF or RTF
09-30-2007, 06:10 PM
Replies: 930
Views: 93,140
Posted By renwick56

RE: Twist 3D 150 ARF

Thanks Barry -

This is good to know. I am only guessing about needing to go to a 20" prop. This is based upon motor manufacturers suggestions. I am very anxious to get this airplane in the...
Forum: ARF or RTF
09-30-2007, 12:17 AM
Replies: 930
Views: 93,140
Posted By renwick56

RE: Twist 3D 150 ARF

Gibbs -

Apparently electrics do require larger props than one would run on glow/gas engines. I am brand new to electrics, but as I understand it in order to get the watts (=HP) needed I have to...
Forum: Glow to Electric Conversions
09-28-2007, 09:31 AM
Replies: 14
Views: 2,185
Posted By renwick56

RE: Hanger9 Showtime 4D Conversion

Hello Jason -

What has happened to your review on the Showtime 90 electric conversion? I want to do just this, but would love to see what you did, and what you used first. Please let em know....
Forum: ARF or RTF
09-27-2007, 08:47 PM
Replies: 930
Views: 93,140
Posted By renwick56

RE: Twist 3D 150 ARF

Hello Raptor -

I am building a Twist 150, and plan on goin g electric. I was wondering what was the size (height) of the landing gear you are using on yours. I may have to swing a 20" prop, so...
Forum: TEAM RCU - Mike McConville
09-24-2007, 10:54 AM
Replies: 0
Views: 669
Posted By renwick56

Showtime 90 - OS 1.08 or Electric???

Hello Mike -

I am a seasoned R/C flyer, that took a long hiatus from the hobby (>10 years). I have just recently returned to the fold.

I have just purchased a Showtime 90 4D, that I...
Forum: TEAM RCU - Mike McConville
09-24-2007, 08:41 AM
Replies: 3
Views: 1,178
Posted By renwick56

RE: 3D prop size for st with an os 108 2 stroke

MV -

What prop combination did you end up with. Right now I intend on putting a 1.08 in a ST 90 4d. I had used this engine in many airplanes, using a 14x8 prop. Not sure about what to do with...
Forum: 3D Flying!
09-18-2007, 12:54 PM
Replies: 30
Views: 3,834
Posted By renwick56

RE: any one have a FRENZY

I was considering buying of of these, up until I read this thread. After reading this thread, I called Horizon / Hangar-9 regarding the CofG on this airplane. They told me that there should be a...
Forum: 3D Flying!
09-18-2007, 12:33 PM
Replies: 13
Views: 1,655
Posted By renwick56

RE: H9 Twist 150, anyone?

I would like to use an O.S. 1.08 FSR. It's the grandfather of the O.S. 1.20 AX. Do you folks think that this engine is suitable?
Forum: 3D Flying!
09-18-2007, 12:32 PM
Replies: 66
Views: 6,480
Posted By renwick56

RE: Twist 150 and havin fun

What does everyone think about using an O.S. 1.08 to power this plane?
Forum: ARF or RTF
09-13-2007, 04:03 PM
Replies: 480
Views: 66,924
Posted By renwick56

RE: *New H9 Frenzy-100 ARF*

Anyone build this out as an electric? Anyone considering this (besides me, LOL)?
Forum: Glow to Electric Conversions
08-25-2007, 09:42 PM
Replies: 3
Views: 869
Posted By renwick56

RE: What motor,esc, battery to convert a GP Big Stik 60

Thanks Matt for the reply.

8 lbs is the weight.
Please let me know what you think

Ren
Forum: Glow to Electric Conversions
08-25-2007, 09:32 PM
Replies: 3
Views: 869
Posted By renwick56

RE: What motor,esc, battery to convert a GP Big Stik 60

Thanks Matt for the reply.

8 lbs is the weight. :(
Please let me know what you think

Ren
Forum: Electric Training
08-24-2007, 12:35 PM
Replies: 1
Views: 912
Posted By renwick56

battery nomenclature / parameters

I was using MotoCalc to try determine what motor / battery , etc. I should use to convert a GP Big Stik to electric.

I says that the battery should be “7x3200SHD 2P”. What does that mean?
Forum: Glow to Electric Conversions
08-23-2007, 08:29 PM
Replies: 3
Views: 869
Posted By renwick56

What motor,esc, battery to convert a GP Big Stik 60

I am totally new. to electrics I have a GP Big Stik 60 airframe, that had been powered by an OS 1.08 (BX-1). It's heavier than stock, as it is covered with Coverite, and painted with Hobby Poxy...
Forum: Electric Training
08-21-2007, 11:26 AM
Replies: 2
Views: 674
Posted By renwick56

Need to learn everything about

Hello All;

I have been flying R/C Airplanes and Helicopters since 1979. I took a brief hiatus (>10 years) from the hobby, but a trip to my local flying site last week opened my eyes to several...
Forum: RC Pattern Flying
12-03-2003, 11:35 PM
Replies: 8
Views: 2,181
Posted By renwick56

RE: Mistress part II

This is a great airplane! I have been out of the hobby for about a decade, and I am just beginning to take it up again. My Mistress is powered by a YS 61 LS. I will replace this powerplant with a...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.