RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: Marcos_Nieto
Showing results 1 to 25 of 101
Search took 0.71 seconds.
Forum: Futaba Radios Direct support forum
06-22-2005, 10:13 AM
Replies: 5
Views: 843
Posted By Marcos_Nieto

RE: Is it safe to fly below 4.8 volts??

Thank Bill...................I usually stop flying when the volt is just under 4.8 volts and always check after landing. Lowering the low volt limit, say 4.65 v, will give me much more flying time...
Forum: Futaba Radios Direct support forum
06-15-2005, 10:39 AM
Replies: 5
Views: 843
Posted By Marcos_Nieto

Is it safe to fly below 4.8 volts??

Hi guys..........I use, in most planes, high capacity packs. Recently I´ve been getting less than expected fly time. So I recycled all my packs and found that 2 of my 2000 mAh/4.8 volts. delivered...
Forum: Batteries & Chargers
06-14-2005, 02:22 PM
Replies: 17
Views: 2,216
Posted By Marcos_Nieto

RE: Is it safe to fly below 4.8 volts??

Ok, that´s what I always do, fly till the volt. drops to 4.8. But as the fly time was shorter than expected, I decided to recycle the packs down to 4 volts.....And surprise, most of the charge of 2...
Forum: Batteries & Chargers
06-14-2005, 10:18 AM
Replies: 17
Views: 2,216
Posted By Marcos_Nieto

Is it safe to fly below 4.8 volts??

Hi guys...........I´ve been trying to find what´s wrong with some of my high capacity packs that deliver only a fraction of their rated capacity.....I found out that these reduced capacity packs...
Forum: Batteries & Chargers
05-16-2005, 03:17 PM
Replies: 8
Views: 935
Posted By Marcos_Nieto

RE: Accu-Cycle Elite Calibration-Help

No, I´m not sure that the problem is the Accu-Cyle Elite. And yes my Elite is under warranty; the problem is that I live in Venezuela and therefore need to make sure there is a problem with the...
Forum: Batteries & Chargers
05-16-2005, 12:39 PM
Replies: 5
Views: 1,306
Posted By Marcos_Nieto

RE: Battery Pack impedance-Very important factor

Hi Mr.rc-cam...............thanks for your time. Have you any address where I can get that info?? I´ve been looking at Sanyo´s and Panasonic´s pag. but no specs on this subject. They have general...
Forum: Batteries & Chargers
05-16-2005, 09:18 AM
Replies: 5
Views: 1,306
Posted By Marcos_Nieto

Battery Pack impedance-Very important factor

Hi guys....................I´ve been reading some articles on batteries in order to decide what pack to buy in replace to some old ones. But, is the internal impedance a mayor factor in volt. drop...
Forum: Batteries & Chargers
05-13-2005, 12:44 PM
Replies: 8
Views: 935
Posted By Marcos_Nieto

RE: Accu-Cycle Elite Calibration-Help

Yes Laryboy.......that´s right. But you are assuming that the discharge rate is 250 mA, and that is what I am trying to determine: if the charge rate, discharge rate, cutoff voltage are what is...
Forum: RC Warbirds and Warplanes
04-13-2005, 07:43 AM
Replies: 117
Views: 18,635
Posted By Marcos_Nieto

RE: INSTALLING THE REVOLUTION 52 AND SCALE EXHAUST ON THE TOP FLITE ARF P-51

Samuel.......nice job on your P-51. Only one suggestion....smooth out those cuts on the firewall. Angles cuts and specially small angles cuts may cause cracks to progress from the vertex of the...
Forum: RC Warbirds and Warplanes
04-05-2005, 02:05 PM
Replies: 102
Views: 14,528
Posted By Marcos_Nieto

RE: Flew Great Planes Stuka

Bob if you can find one do not hesitate, buy it, it is worth every penny. I didn´t know it was discontinued...I have one for about a year now (over 150 flights) and it is a great flier, easy on...
Forum: RC Warbirds and Warplanes
04-01-2005, 09:17 AM
Replies: 10
Views: 1,067
Posted By Marcos_Nieto

RE: First Warbird

Hi..............go for the GP Stuka. Nice looking easy to fly, no retracts. One thing to be aware of is the weak ail performance....If you mix Flaps-ail to work both as ail, no problem...this plane...
Forum: 3D Flying!
01-24-2005, 02:47 PM
Replies: 5
Views: 716
Posted By Marcos_Nieto

RE: Funtana 90 control set ups

Hi guys............I´m also ready for the first flight of my Funtana 90. What about CG?? That´s a mayor factor on plane performance.
Thanks
Marcos
Forum: 3D Flying!
01-21-2005, 08:38 AM
Replies: 3
Views: 605
Posted By Marcos_Nieto

3D-Basic settings for success

Hi guys.........I´m new to 3D and I´ve been practicing in simulator before attempting the very difficult maneuvers with my plane..But there must be some basics settings that every body trying these...
Forum: 3D Flying!
01-18-2005, 01:57 PM
Replies: 8
Views: 991
Posted By Marcos_Nieto

FuntanaS 90-Weak control horn

Hi guys................In the Funtana 90 instruction manual the ball joint used in the ail push rod is placed on the push rod control horn end. This requires to enlarge to 3/32 one of the connecting...
Forum: 3D Flying!
01-13-2005, 05:26 PM
Replies: 6
Views: 852
Posted By Marcos_Nieto

RE: 3D and gyros

Thanks guys.......Definitely all try all those challenging maneuvers without gyros. I´ll spend time in the sim before attempting the very difficult ones on the field.
Thanks again
Marcos
Forum: 3D Flying!
01-12-2005, 04:59 PM
Replies: 6
Views: 852
Posted By Marcos_Nieto

3D and gyros

Hi guys.............I´m new in 3D and learning the different techniques like Hover and rolling harrier using 3G sim package before attempting to do it with thereal thing.....I´m also looking at...
Forum: 3D Flying!
12-14-2004, 06:19 PM
Replies: 5
Views: 681
Posted By Marcos_Nieto

RE: First time 3D flyer. Help needed

Thanks guys.......I´m sure will be of great help :D
Marcos
Forum: 3D Flying!
12-13-2004, 10:11 PM
Replies: 5
Views: 681
Posted By Marcos_Nieto

First time 3D flyer. Help needed

Hi guys.................Where can I get instructions on 3D flying?? Is there any book or publication on "How to" perform, settings, mixes, safety etc??
Thanks....
Marcos
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
12-06-2004, 02:54 PM
Replies: 2
Views: 582
Posted By Marcos_Nieto

Harry Higley 9C book-Good stuff

Hi guys...........After over 1 year with my Futaba 9C radio finally I decided to buy a decent book and get rid of the Owner Manual that comes with this radio....what a wonderful radio the 9C...
Forum: 3D Flying!
11-30-2004, 03:01 PM
Replies: 1
Views: 415
Posted By Marcos_Nieto

FuntanaS 60 engine cooling

Hi guys................I´m in the process of installing the cowling to my Funtana 60/OS 120 combo. The cowling of this plane has no rear opening for ventilation and only the valve cap will stick out...
Forum: 3D Flying!
11-17-2004, 01:22 PM
Replies: 2
Views: 530
Posted By Marcos_Nieto

FuntanaS 90 servos and hinges

Hi guys...........I plan to use Hitec 635 HB Karbonite servos in my FuntanaS 90 and want some comments on this plane/servos combo.
Also I´m concern on using the CA hinges included in the kit as...
Forum: Composites Fabrication And Repair
11-17-2004, 09:32 AM
Replies: 1
Views: 504
Posted By Marcos_Nieto

Sealing surface hinge gap-Help needed

Hi guys..............I´m building a plane with huge ailerons, rudder and elev. and the manufacturer recommends that all surfaces hinge gap be sealed. Some gays out there recommend to do this using...
Forum: 3D Flying!
11-15-2004, 07:33 PM
Replies: 5
Views: 652
Posted By Marcos_Nieto

RE: FuntanaS 90 wing/aileron gap

Thanks guys for your time and interest...............That I´ll do, seal the gap.....One more question. When sealing the gap you do it one side or both, top and bottom of wing??
Thanks again
...
Forum: 3D Flying!
11-15-2004, 01:34 PM
Replies: 5
Views: 652
Posted By Marcos_Nieto

FuntanaS 90 wing/aileron gap

Hi guys.............I´m in the building process of my FuntanaS 90 and want to know if it is necessary to seal the wing/ail gap that in my case it is about 1/32.
By the way can someone out there...
Forum: RC Warbirds and Warplanes
11-02-2004, 02:43 PM
Replies: 4
Views: 543
Posted By Marcos_Nieto

Retracts fo TF .60 P-51

Hi guys..................I´m looking for a pair of air retracts for a Top Flite .60 P-51 and want to know if someone out there can help me deciding between the Robart 605HD and Robostruts and the...
Showing results 1 to 25 of 101
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.