Hi

Can anyone help me with my simjet 2300.After finally being able to get the instruction manual from CARS II,i have yet again reached a dead end.

I have rigged up the system according to the manual

I put the tx,rx and the Ecu on and the green light is blinking so far so go

so i start pushing the throttle trim up but no yellow light till the very top of the trim lever and the green light still flashing.

No responce to any other trim movement

so i cycle the throttle lever and the engine comes alive but still no yellow light and the starter stops and starts about 6 times and shuts down (like cooling cycle)

please can anyone help and let me know what i can check coz i live in india and before i send it to the company i would like to eleminate all the possiblites

Thanks

Capt Prahlad

[email protected]

When you move the throttle to full power, leave it there till the yellow led comes on,(5 secs?) then move back to idle and it should start.

HI Capt

What Radio system are you using?

Ed

hi,

thanks for the interest if i keep the stick up for 5 sec the seq starts but still no YELLOW light.

I have tried everything and i am fedup now and dont know what to do.

As i do not much experience with this engine

and feels like a mistake buying a second hand engine.

THanks

Capt Prahlad

Hi Ed,

I am using a JR PCM 9 X radio( PCM ).