cconeill

Thanks Alex. may try the motors. but not ready to by lipos. back to gas. Craig

cconeill

Axel would this cooling rung fit these motors?? for 20 bucks a motor I will give this a try. but need a cooling ring for sure.
Water Cooling Motor Mount 30mm

cconeill

got a question guys. had these outrunners in another boat. plan on useing them in the xcat to get my speed up. will the 120amp turnigy esc be ok? and who makes a cooling block for a motor this size.

axel2

No they are to smal bolting space must be 25 mm

Axel

axel2

The motor has not enough rpm evan on 10S

Axel

cconeill

Hi Axel so if I go with an in-runner what should I be looking at. not worried about useing OB. looking for speed useing stingers. Thanks Craig

axel2

Craig for same Power output you have to use double to three times the weight of the motors. I would stay with Outrunners.
If you want to stay with 6S
https://www.hobbyking.com/hobbyking/...dproduct=36805
and for 12S
https://www.hobbyking.com/hobbyking/...dproduct=37461

Axel

cconeill

Hi Guy's I have ordered tp power 4040 9d motors and 6s 5000mah lipos for the xcat. these little cats are amazing. the new setup will make it run really nice. Thanks to all who helped out. Axel check out my twister cat. it will be 36x13x7.5 will have the same 4040 motor on 6s. both will be a blast to run. will finish up the plans this weekend. just to cool

axel2

Looks good - i like it - will follow

cconeill

new setup on my xcat. it screams!! luv it. two TP 4060 9y on 6s. 180 amp esc and a servo with 334 oz. of torque. such a cool cat!!

https://www.youtube.com/watch?v=XPeFf4nxnYg

dirk_

hi mr o`neill

oh oh .. a lang time i was not here ......
LOOKS GOD , THE FLYING "X" ! ! ! !
you use the old proboat outborder ?
greets dirk