I have my nitro vee and sv27 at my grandparents andthey both screwed up so please help

1st: On my sv27 i turned on the tx then pluged in the batts and it did its beeps then pulled the trigger like always and it didnt beep and put the throttle reversing swich on then swiched back qnd it beeped so i run it and the steering is unresponsive turn right and it stays right then gliches the goes strait again the the boat keeps going while im not even holding the trigger then stopps and nothing works. I need help figuring this one out any quetions are ok!

2nd: my nitro vees servos have a mind of their own and i dont know what is causing the problem. I Ran it then it goes to full throttle and had to steer it by the dock and catch it and the servo was gliching and holding full throttle then i shut the motor off and the steering servo started turnng to the right so i turned the boat and reciever off and the servo still moved! Please help

Anyone? Any sugestions

I had/have a nitro v as well.  Traxxas servos are supper crapy when they get wet, and in those old boats they got wet.  They tend to have a mind of their own.  You can attempt to open and clean them, but once they have glitches like that, it doesn't take much moisture for them to glitch again.  I would replace the glitching servos in the V.<div>
</div><div>As for the SV 27, I don't know, but it sounds like the rx is shot.</div>

Ok i will get waterproof ones and i keep getting fuel in the hull where a tube goes to the stuffing tube, im guessing fuel goes into the stuffing tube? But its leaking and want it to stop

fuel goes into the stuffing tube <<<< huh ???

Fuel goes to the drive shaft to lubricate it and i thnk its leaking

Post up some clear pics

Ok will do

sorry about the quality ill get better ones tomarro if needed