RE: Super G' owners ~~ This is our thread
 

will the cy 26cc water cooled work in the gator and do i need to use differnt motor mounts or can i use the ones the boat came with thanks jim

RE: Super G' owners ~~ This is our thread
 

2day I got my new ENFORCERSUPERG! YEEEEEEEEEEEEEEEEEEEEEES

Now i only need some good weather,lol

RE: Super G' owners ~~ This is our thread
 

Welcome to the addiction.

Leo

RE: Super G' owners ~~ This is our thread
 

Lol, Thanx

AQuestion!

What is the easiest way to remove the drive shaft after a run?

RE: Super G' owners ~~ This is our thread
 

I cannot see which drive you have on the gator but if I had to guess I would say it's a version of the XP-2.

Start by removing the strut adjustment bolt.
Slide the Strut down and pull the assembly out of the shaft.
You may or may not need to loosen and tilt the rudder up to get the assembly out.

I have attached page 4 of Tony's instructions that covers the proper steps to replace the cable. I hope this helps.

Leo

RE: Super G' owners ~~ This is our thread
 

tomorow its time for 1st try with the Super G,

Hope its not stalled, have no retrival boat....!!!!!!!!http://www.rcuniverse.com/forum/js/f...used_smile.gif</p>

RE: Super G' owners ~~ This is our thread
 

That motor is almost problem proof lol I put the same motor in my brothers gator a while back and the only problem we have had is sometimes hard to start when cold its never stalled on the water with us very reliable. Good Luck
Scott

RE: Super G' owners ~~ This is our thread
 

Is that the Zenoah RC230?
If so, just like Scott said its a fantastic engine. Pretty much bullet proof and mine have ran 40mph right out of the box. Not bad for a play boat. Enjoy the soft water while you can.

RE: Super G' owners ~~ This is our thread
 

Off the top of your heads, can anyone tell me what type of resin is used in them (poly or epoxy)? If you remember my Team Pro that got tossed on the rocks a few years ago is needing some attention this winter. Can't sell it & get enough out to justify the shipping so might just glass & go. Beater boats seem to run the best anyhow.

RE: Super G' owners ~~ This is our thread
 

Poly resin is my guess,as far as i know all his boats are poly resin.
Mart

RE: Super G' owners ~~ This is our thread
 

2Day was the first time i tested my ENFORCERSUPERG and that was better than sex(Not).
I have been in RC cars,helis,planes but this is awesome!!!!!

No stalls no problem at all! Just FUN!!!!!!

Yeeeeeeeeeeepiiiiiiiii!!!!!!!!......LOL

RE: Super G' owners ~~ This is our thread
 

http://www.rcuniverse.com/forum/js/f...ular_smile.gif</p>

RE: Super G' owners ~~ This is our thread
 

I just got a new Super G and I am going through the process of setting up the radio equipment. I do have one question: does anyone the hex size of the grub screw that holds the throttle linkage to the bradded cable line? it's smaller than the smallest hex tool i have which is 1.5mm.