quick question with hammer....
08-24-2005 | 09:36 PM
#1
Thread Starter
Senior Member
Joined: Aug 2005
Posts: 2,544
Likes: 0
Received 0 Likes
on
0 Posts
From: greendale,
IN
quick question with hammer....
just got back from the lake for my hammer run, i'm well satisfied of todays performance 
the only thing is during high speed the bow won't raise up 
about 50% of the hull has contact with the water, i wanna go lesser than this, is it possible? what adjustment or mods do i need?..everything is stock except i raised the rudder bracket by 3/4 "..thanks in advance,,,
the only thing is during high speed the bow won't raise up about 50% of the hull has contact with the water, i wanna go lesser than this, is it possible? what adjustment or mods do i need?..everything is stock except i raised the rudder bracket by 3/4 "..thanks in advance,,,
08-25-2005 | 07:22 AM
#2
RE: quick question with hammer....
Bend up the trim tabs a bit. Just keep in mind though that the hammer still has a fair bit of the hull in the water when running. Its not a surface drive gas boat going 50mph+.
