Edge 540t question
03-26-2005 | 05:11 PM
#1
Thread Starter
Senior Member
Joined: Jun 2004
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
From: QC,
QC, CANADA
Edge 540t question
Hi guys !
I was wondering that there is a openning from the cowl to the tail..Like all others....should I put a ply sheet so the air wont come in the fuse when the motor will run ??! Or just leave it like this ?!?!
thx Julien
I was wondering that there is a openning from the cowl to the tail..Like all others....should I put a ply sheet so the air wont come in the fuse when the motor will run ??! Or just leave it like this ?!?!
thx Julien
03-26-2005 | 08:34 PM
#4
Senior Member
Joined: Jul 2004
Posts: 869
Likes: 0
Received 0 Likes
on
0 Posts
From: Wisconsin Rapids,
WI
RE: Edge 540t question
Not that you fly like this but. I have seen a few pilots make mistakes on there final and if you field is like ours you have some tall grass out there. Well if you ever spend any time flying in the weeds you will wish you had covered that whole.
03-27-2005 | 11:29 AM
#6
Senior Member
My Feedback: (14)
Joined: Dec 2001
Posts: 2,460
Likes: 0
Received 0 Likes
on
0 Posts
From: MT Vernon,
WA
RE: Edge 540t question
Hot Tip!!!!!!!!
ORIGINAL: Silversurfer
If you decide to cover any of the openings up, use Monokote or Ultracote. They are a lot lighter than wood and much easier to remove later.
If you decide to cover any of the openings up, use Monokote or Ultracote. They are a lot lighter than wood and much easier to remove later.
