We had a super day for Decemeber in Arkansas 54 and sunny with a 3 to 6 mph wind out of the north. I have been working on my Hairers got brave and pointed the nose down let it fall and yanked in full up and did my first terminator. It pitched the nose up at about a 45 degree angle and just locked right in to a hairier. It has been 4 years since my last Cap I new this one was going to bee fun Thanks Tom for another great plane. Tim

Would you give us a flight report as well as setup and engine choice. If you have the all-up weight, that would also be appreciated.. Did the airplane build straight and did everything fit good. I am thinking of getting one and putting the ZDZ80RV on it.

The cap Cap came out at 20lbs & 6oz, it has 2 mpi switchs with built in 6 volt regs 2, 2400 fromeco batts a 24 oz dubro tank, hanger nine hardware with central hobbies carbon fiber/ titaium rods. The motor is a 3w-75ius a 2400 fromeco & 5.1 reg and a jr heavy duty switch, Dave Brown 3.5" spinner with lighted back plate, 24x10 3-w wood prop. Servos are 5645 hitec's in the wing,5955 tg on the elevators,and 1-5745 1/4 scale digi on rudder with Don,s hobby shop pull-pull set up. There is no pilot,dash or wheel pants I hit the CG dead on with out adding weight any where just moving the batts around.
will send pick of setup on inside if that will help.