YS 63S Won't Hold Idle
#1
Junior Member
Thread Starter
Join Date: Nov 2004
Location: Hong Kong, HONG KONG
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
Hi dave,
Break-in the 63S on test stand with CP 30% heli for 6 full tanks (12oz.) then install it up side down on the plane. Problem is every time I fire it up & remove the glow then the RPM goes down slowly until engine stop & lot of fuses came out from the cab & the exhaust. do you think I need to adjust the LS neddle (anticlockwise) or the regulator (clockwise) to prevent more fuse to the engine & will it help to get better idle?
HS neddle setting is 1 3/4 turn out & tank location is 2cm above the cab. do you think it will caused the problem?
Break-in the 63S on test stand with CP 30% heli for 6 full tanks (12oz.) then install it up side down on the plane. Problem is every time I fire it up & remove the glow then the RPM goes down slowly until engine stop & lot of fuses came out from the cab & the exhaust. do you think I need to adjust the LS neddle (anticlockwise) or the regulator (clockwise) to prevent more fuse to the engine & will it help to get better idle?
HS neddle setting is 1 3/4 turn out & tank location is 2cm above the cab. do you think it will caused the problem?
#2
Senior Member
![Default](https://www.rcuniverse.com/forum/images/icons/icon1.gif)
No problem with the tank height. The regulator is leaking. Try turning it in 1/4 to 1/2 turn to see if the carb leak stops. If it doesn't, the reg could have a piece of debris holding the plunger off the seat. Take the reg apart and clean it if turning the screw clockwise doesn't help.