RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: gclow
Showing results 1 to 16 of 16
Search took 0.21 seconds.
Forum: Exceed RC Support - Helicopter
04-17-2010, 06:19 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

New day,
New "hard" landing.

Tail rotor is slipping again.  Will rebuild next week and try it again.
Forum: Exceed RC Support - Helicopter
04-12-2010, 03:43 PM
Replies: 3
Views: 1,652
Posted By gclow

RE: Crash, smoke bent main shaft

If you have never set up the pitch for the main rotor blades there exists a 2  part series on youtube at:

http://www.youtube.com/watch?v=VArYrRQ4dxw&feature=fvw

Watch both before you start,...
Forum: Exceed RC Support - Helicopter
04-12-2010, 03:35 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

Andy,

Good news, I discovered that while installing the retention strap for the receiver and gyro that the gyro was switched to NOR.

Switched it to REV, and fixed that issue.

Now the last...
Forum: Exceed RC Support - Helicopter
04-08-2010, 10:11 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

Andy,

helicopter is back together, down to a new issue.
(This is good news, the transmitter and servos are working great)

The gyro, initializes then no services provided by the gyro.
The LED...
Forum: Exceed RC Support - Helicopter
03-09-2010, 12:49 AM
Replies: 7
Views: 1,566
Posted By gclow

RE: raptor g2 all over the place

you are somewhat lucky as the Walkera 36 manual mirrors your heli.

Don't necessarily believe the dip switch settings, but they will probably be a good place to start.

If you are not able to...
Forum: Exceed RC Support - Helicopter
03-04-2010, 11:41 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

Andy,

You are great.

I appear to be down to just a few issues.

Honestly won't know until after a couple more flights.

Gene
Forum: Exceed RC Support - Helicopter
03-04-2010, 11:32 PM
Replies: 7
Views: 1,566
Posted By gclow

RE: raptor g2 all over the place

I went through a similar scenario with my G2 SE.
While rebuilding it after a crash, I read what there is of the manual and made changes to several settings.
I was focused on dip 10 and 11 - big...
Forum: Exceed RC Support - Helicopter
03-02-2010, 11:25 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

Andy,

What a learning experience. I'd actually rather be learning how to fly my G2 SE than repairing it. (but it is raining, so this is the time to "get it right")

Recent actions:
I downloaded...
Forum: Exceed RC Support - Helicopter
03-01-2010, 06:04 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

Thank you,

Parts arrived last week, finished repair yesterday.

I will make those changes to my tx tonight, and flight check the heli.

Gene
Forum: Exceed RC Support - Helicopter
02-18-2010, 12:44 PM
Replies: 82
Views: 36,563
Posted By gclow

RE: Exceed-RC Raptor G2 Keeps Spining

Thank you,
Forum: Exceed RC Support - Helicopter
02-18-2010, 12:12 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

About a week ago, I verified dip switch settings as described in the aircraft manual.

Now, I'm concerned that the dip switch settings are part of the problem.

Where can I get a guide to the...
Forum: Exceed RC Support - Helicopter
02-18-2010, 12:10 PM
Replies: 14
Views: 3,562
Posted By gclow

RE: Helicopter Still Spinning

That is the part I replaced.

I read a blog where the poster made changes to the #12 dip switch.
I made those changes, and the gyro now locks on immediately.

I flew the helicopter and it still...
Forum: Exceed RC Support - Helicopter
02-16-2010, 03:52 PM
Replies: 6
Views: 2,479
Posted By gclow

RE: Default settings for transmitter

Andy, are those the same settings for the G2 SE?

Mine are factory set at 2, 4, 6.

The manual states 4, 8 as the defaults.
Forum: Exceed RC Support - Helicopter
02-16-2010, 03:48 PM
Replies: 14
Views: 3,562
Posted By gclow

Helicopter Still Spinning

I replaced the tail drive on my G2 SE.
It spins counter clockwise.
I have made several adjustments and it won't stop.
I read the blog, took the tail drive assembly apart, glued the sprocket to the...
Forum: Exceed RC Support - Helicopter
02-15-2010, 09:55 PM
Replies: 82
Views: 36,563
Posted By gclow

RE: Exceed-RC Raptor G2 Keeps Spining

Please verify that the gyro has to be set to reverse.

Thank you,

</p>
Forum: Walkera Helis - Dragonfly, etc..
02-15-2010, 09:49 PM
Replies: 4
Views: 1,234
Posted By gclow

RE: Which Walkera Dragonfly is the best?

I owned a 4 channel ExceedRC Falcon 40 with NiMH batteries.
After the 40 or 50th flight, it too would only lift about 2 to 6" off the ground.
At first I thought it was the battery, but then it did...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.