RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: sweendog1969
Showing results 1 to 25 of 54
Search took 0.53 seconds.
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
10-10-2015, 03:06 PM
Replies: 8
Views: 748
Posted By sweendog1969

Sw3 or motor issue.

I have a sprint 2 flux with the sw3 and stock motor setup with stock gearing. It was running great then the last run i noticed the esc didnt make a tone when i plugged my pack in. Then the motor...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
02-08-2015, 07:26 PM
Replies: 6
Views: 2,826
Posted By sweendog1969

I have the tamiya rx7 body on my slash. looks...

I have the tamiya rx7 body on my slash. looks like the hillbilly camaro,mustang on 4x4 jobs you see floating around the web.
Forum: RC Electric On-Road vehicles, race cars and more
10-03-2013, 09:50 PM
Replies: 3
Views: 476
Posted By sweendog1969

depends on the condition. And if people want it...

depends on the condition. And if people want it in the condition it is in i.e. bone stock or modified. And how old the electronics are.
Forum: RC Classic Cars & Trucks
10-03-2013, 09:31 PM
Replies: 290
Views: 169,909
Posted By sweendog1969

if you run it alot you might want to gut the...

if you run it alot you might want to gut the stock electronics and put a "hobby" grade radio,speed controller and motor if you can find one that would properly fit.
Forum: RC Drifting
09-16-2013, 06:22 PM
Replies: 4
Views: 990
Posted By sweendog1969

I know this thread is basiclly dead,but....does...

I know this thread is basiclly dead,but....does anybody know where I could find a couple either high speed or stock gear sets......had a 9t reedy touring car motor w/one way front diff and man was...
Forum: RC Drifting
09-16-2013, 06:03 PM
Replies: 12
Views: 3,819
Posted By sweendog1969

buy a water proof speed controller and a...

buy a water proof speed controller and a waterproof box for your receiver and then just keep it out of the puddles. And be prepared for everything like bearings,hardware,axles,basically anything...
Forum: RC Drifting
09-16-2013, 05:57 PM
Replies: 4
Views: 1,090
Posted By sweendog1969

i have used the original expanding gorilla glue...

i have used the original expanding gorilla glue to lock a few diffs. Just make sure to shove the axles/junk axles to fill the holes or you wont be able to get the axles into the holes because...
Forum: RC Electric On-Road vehicles, race cars and more
09-15-2013, 09:23 PM
Replies: 763
Views: 214,637
Posted By sweendog1969

Has anyone figured out a way to use regular style...

Has anyone figured out a way to use regular style hubs with the nuts and not whatever it came with? The first mod I did to mine is rip of the calipers due to the slop in the wheel hitting them and...
Forum: RC Car General Discussions
09-15-2013, 12:32 PM
Replies: 12
Views: 776
Posted By sweendog1969

i am sort of a lipo noob myself...however not a...

i am sort of a lipo noob myself...however not a noob to r/c. I have heard that you dont need to discharge a lipo battery before you charge it,like a nimh pack they dont have memory. Just dont go...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
09-12-2013, 07:06 PM
Replies: 35
Views: 8,447
Posted By sweendog1969

I am now having stage 1 high temp "shut off" I am...

I am now having stage 1 high temp "shut off" I am running a stock setup. Stock motor,speed controller,and gearing. Stock tires,drive shaft everyting stock. For a battery I am running Onyx 11.1...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
08-14-2013, 07:41 PM
Replies: 35
Views: 8,447
Posted By sweendog1969

if you overheat a motor why couldnt you rezap the...

if you overheat a motor why couldnt you rezap the magnets? if it was not in fact the arm that was toasted.
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
08-07-2013, 09:09 PM
Replies: 870
Views: 105,205
Posted By sweendog1969

I used popcicle box cut to shape and used gorilla...

I used popcicle box cut to shape and used gorilla tape to keep the cardboard in shape and in place. I had the problem of rocks getting stuck between the drive shaft and chassis. My car has maybe...
Forum: RC Electric On-Road vehicles, race cars and more
03-09-2013, 08:21 PM
Replies: 763
Views: 214,637
Posted By sweendog1969

RE: Official HPI E-10 Thread

I've had my e10 drift for about two days....For a beginner in non toy grade r/c (you break you can fix/upgrade)its pretty good. However being non noobish to r/c what is with the ni-cad pack? does...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-30-2012, 05:10 PM
Replies: 363
Views: 47,159
Posted By sweendog1969

RE: OFFICIAL 1/16 VXL Slash thread.

Just got some venom racing turnbuckles for 1/16 slash......JUNK. first five minutes of running on gravel and they came appart. Look at them closer and notice half of the thread is of a smaller...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-27-2012, 10:25 PM
Replies: 363
Views: 47,159
Posted By sweendog1969

RE: OFFICIAL 1/16 VXL Slash thread.

Integy is junk....have an Integy steel cage for my 2.5 rustler..never been attached because it so bent up and miss aligned. the packs dont seem to move around alot.....unless the battery door comes...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
12-24-2012, 09:02 PM
Replies: 363
Views: 47,159
Posted By sweendog1969

RE: OFFICIAL 1/16 VXL Slash thread.

Just have several questions.Does the proline vw bug body fit the 1/16 slash fairly easy? Mainly worried the body posts wont go up high enough. Has anyone used aluminum battery box doors? I mean...
Forum: Toy-Grade RC Products
05-09-2011, 05:46 PM
Replies: 17
Views: 7,332
Posted By sweendog1969

RE: Rat Shack 4x4

I've modded a couple of those chassis from rat shack. Has anyone figured out a way to replace/eliminate that stupid plastic diff that is in there? On my first truck it was RWD only and would pull...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
09-30-2010, 10:18 PM
Replies: 19
Views: 13,964
Posted By sweendog1969

RE: Traxxas 1/16 e-revo vs 1/6 slash

The stadium/short course trucks this thing is modeled after don't seem to handle that well to begin with. I remember tamiya stadium trucks would go like heck and lean and go around corners on three...
Forum: RC Nitro Stadium Trucks
12-11-2009, 11:54 PM
Replies: 8
Views: 5,635
Posted By sweendog1969

RE: :-: OFFICAL NITRO RUSTLER :-:

I have the 2.5 rusty bone stock exept for the integy steel cage I recieved the other day. My problem is how does it go on? Do i need longer screws or what? I tried willing it to the chassis with...
Forum: RC Giant Scale Cars
12-11-2009, 02:42 AM
Replies: 46
Views: 9,960
Posted By sweendog1969

RE: steel roll cage from Integy

I dont know if Integy sucks or is the best stuff in the world. I just need to know how to properly install the new steel cage for the 2.5 rusty(L5XYS703
Integy Steel Roll Cage TRA Nitro...
Forum: RC Giant Scale Cars
05-28-2009, 11:47 PM
Replies: 53
Views: 3,654
Posted By sweendog1969

RE: decent electric 1/6 cars?

i know this post is pretty much dead....'07 but i bought a 1:6th dale earnhardt nascar off of ebay for $20 plus shipping and was thinking of modding it with a steering servo and reciever and was...
Forum: RC Monster Trucks
03-13-2009, 10:23 PM
Replies: 138
Views: 9,617
Posted By sweendog1969

RE: Age ????

24, and i got started with "hobby" r/c's a long time ago when they where still running the old style f-1's and indy cars,then i had the r.c car action car of the year nitro 4-tec , then a crappy...
Forum: RC Car General Discussions
03-13-2009, 10:13 PM
Replies: 70
Views: 8,155
Posted By sweendog1969

RE: front wheel drive?!?!?!????!?

especially when you have 8 cylinders to throw around!
Forum: RC Electric On-Road vehicles, race cars and more
03-09-2009, 11:47 PM
Replies: 10
Views: 1,049
Posted By sweendog1969

RE: Electric Cars

if its going to be a stricktly streeter or even a drifter i've been running tl-01's and ff02's as streeters and they are durable and with a good esc and motor backed up with a battery can go quite...
Showing results 1 to 25 of 54
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.