Anyone out there done anything other than the closed loop set up on the Hype 3D?

Does the closed loop work well enough and positively enough?

Anyone using a pushrod idea?

I'm not keen on cutting into the rear of the fuselage and mounting standard sized servos as I think the strength will be compromised. Neither do I think mini servos will stand the test of time on the elveators.

Any thoughts/info?

Thanks

The pull pull works very well. Pain to set up. Took me a few hours to do the elevator and rudder.

Use the pull pull system,the whole model is set up for it and from what i heard it works well! I used two standards in the tail strength wasn't the problem the tail is as strong or stronger after I beefed it up however you'll find your c of g way back in 190 - 200 mm's and they recommend 180 max.