i need help setting up servo horn for elevator on FuntanaS 90, if i used "Y" cable i have to counter faced the servo horn (between left elevator and right elevator servo) but the lingkage travel and deflection has different measurement for the left and right elevator. I also tried program mixing on my JR 8310 using elevator -> Aux3 mixing but i cant trim elevator function from the digital trim next to the stick, i had to trim the elevator and AUX3 separetly (which is pain in the &%$*)

Please help me if anyone have other solution for this horn and linkage setting... I can reprogram the servo (if i used digital Hitec servos) but it will cost alot just for 2 elevator servos...
i tried to move the servo mounting so i can use "Y" cable without worrying about the linkage travel and deflection but the fuselage will look wierd...

thanks for any solution....

It sounds to me like you are in need of a:
"reversing Y harness"

These are made for 2 elevator servos reversing
one servo so they both travel in the same direction
on the plane...

thanks a lot, i managed to get one