CG Ultimate arf help!!
#1
Thread Starter
Senior Member
Joined: Jul 2002
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
From: Cabo San LucasBaja California Sur, MEXICO
I just bought a used Ultimate ARF from C.Golberg with out a manual!
Can somebody help me with the C.G., and elevator, rudder and ailerons trows?
Thanks
Can somebody help me with the C.G., and elevator, rudder and ailerons trows?
Thanks
#2
Senior Member
Joined: Dec 2001
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
From: Rockford,
IL
"To determine the Center of Gravity, measure back on the fuselage 2 3/8" from the leading edge of the bottom wing. The C.G. range for this aircraft in 1-7/8" to 2-7/8". Ti is recommended that you balance this model upside down."
From my instruction manual.
SearchMan
From my instruction manual.
SearchMan
#3
Senior Member
Joined: Dec 2001
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
From: Rockford,
IL
Setting Control Surface Travels:
Aileron: Gentle= 10 degrees, Aerobatic = 12 degrees
Elevator: Gentle= 12 degrees, Aerobatic = 14 degrees
Rudder: Gentle= 15 degrees, Aerobatic = 23 degrees
The manual suggest that you start by flying this model with the High rates set at the Gentle settings and low rate set at 75% of the Gentle settings.
Hope this helps,
SearchMan
Aileron: Gentle= 10 degrees, Aerobatic = 12 degrees
Elevator: Gentle= 12 degrees, Aerobatic = 14 degrees
Rudder: Gentle= 15 degrees, Aerobatic = 23 degrees
The manual suggest that you start by flying this model with the High rates set at the Gentle settings and low rate set at 75% of the Gentle settings.
Hope this helps,
SearchMan
#4
Thread Starter
Senior Member
Joined: Jul 2002
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
From: Cabo San LucasBaja California Sur, MEXICO
searchman:
thank you very much, if you ever come down for vacations to Cabo San Lucas in Baja Mexico, you will have a plane to fly on Saturday!!
gracias!!
thank you very much, if you ever come down for vacations to Cabo San Lucas in Baja Mexico, you will have a plane to fly on Saturday!!
gracias!!



