DX6i
07-12-2011 | 04:22 PM
#1
Thread Starter
Joined: Sep 2007
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
From: Westwego, LA
DX6i
I have the DX6i transmitter and its program to the You Can Do aircraft. I have the ailerons mix but they are moving in the wrong directions. When I go into the setup to reverse them they only do one side of the ailerons and not both. How do I get both to reverse correctly?
07-12-2011 | 04:59 PM
#2
Senior Member
Joined: Nov 2010
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
From: Tyler TX
RE: DX6i
ORIGINAL: mrcoolpop
I have the DX6i transmitter and its program to the You Can Do aircraft. I have the ailerons mix but they are moving in the wrong directions. When I go into the setup to reverse them they only do one side of the ailerons and not both. How do I get both to reverse correctly?
I have the DX6i transmitter and its program to the You Can Do aircraft. I have the ailerons mix but they are moving in the wrong directions. When I go into the setup to reverse them they only do one side of the ailerons and not both. How do I get both to reverse correctly?
If i remember correctly you need to revierse your aux channel. that will make them move the correct way.
07-14-2011 | 10:58 AM
#5
Joined: Nov 2005
Posts: 12,624
Likes: 0
Received 0 Likes
on
0 Posts
From: Poolesville, MD
RE: DX6i
You probably have one channel mixed to another instead of using the ( much easier if available ) flaperon mix.
In this case you may need to swap the mix values... e.g. if they are at -100% to 100% now for the second channel reverse them so they read 100% to -100%.
In this case you may need to swap the mix values... e.g. if they are at -100% to 100% now for the second channel reverse them so they read 100% to -100%.
