is there any way to un-do 5 min expoxy?

i glue a peice on the wrong side[:'(]. i feel stupid

any one?

Use a heat gun to get it really hot, it should soften up and come apart. I would do it outside though or somewhere with good venting... I never had the impression that epoxy gives off much in the way of fumes, but I heated some as I was putting it on the other day and my smoke alarm went off after 30 seconds.....

if it dont work, do you think i can contact great planes and the ship me two new parts?

Most likely... but is it possible to just fabricate new parts?

if you use a heat gun on epoxy it should start to crack. and you can pick away at it. and it will fall apart. you have to get it HOT... and i would do it out side and it does give off some nasty smells.... hope it works well for you..

thanks i just tried it a little in my room, and it did soften it. now i just got to go out side wit out waking my mom

i almost got it just need to get it hotter,

thats good news... just get it HOT.... and u will be OK....

i got it thanks guys