Engine Help
01-25-2008 | 03:10 PM
#1
Thread Starter
Senior Member
Joined: Oct 2007
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
From: Charlotte,
NC
Engine Help
K & B .61 2 Stroke
Which direction do I move the needle valve to richen or lean?
Also, my bearings were gummed up, I cleaned them, but now it seems like there is a little almost non-exsistent con rod slack, is this serious?
Please help me, thanks.[8D]
Which direction do I move the needle valve to richen or lean?
Also, my bearings were gummed up, I cleaned them, but now it seems like there is a little almost non-exsistent con rod slack, is this serious?
Please help me, thanks.[8D]
01-25-2008 | 03:38 PM
#2
Senior Member
My Feedback: (4)
RE: Engine Help
Just as you turn a screw clockwise to tighten it, screwing the needle clockwise will screw it deeper into the hole - which lets less fuel in, thereby making the mixture leaner.
Not sure on Part 2... Did you remove the con rod during the cleaning?
Not sure on Part 2... Did you remove the con rod during the cleaning?
01-25-2008 | 03:44 PM
#3
Thread Starter
Senior Member
Joined: Oct 2007
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
From: Charlotte,
NC
RE: Engine Help
No, I am running it a bit right now, and it seems like it recorrects itself, and starts to run smoother.
Thanks on the needle valve though.
Thanks on the needle valve though.
