Homelite 45cc Carb
06-19-2005 | 06:58 PM
#1
Thread Starter
My Feedback: (17)
Joined: Nov 2002
Posts: 1,427
Likes: 0
Received 0 Likes
on
0 Posts
From: Goodyear, AZ
Homelite 45cc Carb
I have a Homelite 45cc that I want to replace the carb in order to sell a working engine. The carb has never worked right, so I put a carb off a G38 on it and it ran great for quite while until it had to go back on the G38. What is a good replacement carb?
06-20-2005 | 12:20 AM
#2
My Feedback: (16)
RE: Homelite 45cc Carb
The dimensions are venturi sizes, not the throttle bore size.
The Homelite 45 uses a ZAMA C1Q-H44 =14mm =.551" venturi. Zama's have no number cast in venturi inlet
The throttle bore size for theZAMA is 16mm = .630" or a little over 5/8"
The G 38 uses a Walbro WT-338 =13.49mm =.531"= #34 cast in inlet Throttle bore is 17.44mm or 11/16"
The G 45 uses a Walbro HDA48D =15.08mm =.5937"= #38 cast in inlet Throttle bore is 19mm or 3/4"
Enjoy,
Jim
The Homelite 45 uses a ZAMA C1Q-H44 =14mm =.551" venturi. Zama's have no number cast in venturi inlet
The throttle bore size for theZAMA is 16mm = .630" or a little over 5/8"
The G 38 uses a Walbro WT-338 =13.49mm =.531"= #34 cast in inlet Throttle bore is 17.44mm or 11/16"
The G 45 uses a Walbro HDA48D =15.08mm =.5937"= #38 cast in inlet Throttle bore is 19mm or 3/4"
Enjoy,
Jim
