Conversion for carb
07-30-2006 | 06:27 PM
#1
Thread Starter
Senior Member
My Feedback: (5)
Joined: May 2004
Posts: 180
Likes: 0
Received 0 Likes
on
0 Posts
From: Ft. Oglethorpe,
GA
Conversion for carb
My Walbro carb has a 24 stamped in the venturie. What size in mm is this? Also where can I get a new arm for the butterfly?
Thanks
Joel
Thanks
Joel
07-30-2006 | 06:42 PM
#2
Senior Member
My Feedback: (29)
Joined: Jan 2005
Posts: 1,402
Likes: 0
Received 0 Likes
on
0 Posts
From: San Antonio,
TX
RE: Conversion for carb
Joel,
The 24 is 24/64th. It is 9.5 mm. It is a good choice for an 18 to 22cc engine. This is the venturi size (smallest section).
Dave
The 24 is 24/64th. It is 9.5 mm. It is a good choice for an 18 to 22cc engine. This is the venturi size (smallest section).
Dave
07-30-2006 | 10:39 PM
#4
Senior Member
My Feedback: (4)
RE: Conversion for carb
What is the carb number. IE WT... or WA...? According to my formula you would want to try a carb in the 11 to 12mm range which would give you a venturi of 28 which will be cast into the carb also. For a carb arm you could use a steering nose gear arm. The arm would sit on top of the throttle shaft and be held in place by a socket head screw. There are many other ways too.
TIm
TIm
