conversion of a 1.60fx
04-21-2008 | 01:38 PM
#2
My Feedback: (27)
Joined: Mar 2004
Posts: 1,450
Likes: 0
Received 0 Likes
on
0 Posts
From: Woodland,
CA
RE: conversion of a 1.60fx
This is off the Tower Hobby site.
"REQUIRES: Fuel with 18% (minimum) lubricant content and 5% to 25% Nitromethane"
(Can be flown on FAI fuel, which is 0% Nitro)
You would have to maintain the 18% oil, or switch to a roller bearing on the big end of the rod.
Here is a simular thread:
http://www.rcuniverse.com/forum/m_73.../tm.htm7396595
"REQUIRES: Fuel with 18% (minimum) lubricant content and 5% to 25% Nitromethane"
(Can be flown on FAI fuel, which is 0% Nitro)
You would have to maintain the 18% oil, or switch to a roller bearing on the big end of the rod.
Here is a simular thread:
http://www.rcuniverse.com/forum/m_73.../tm.htm7396595
04-22-2008 | 12:58 PM
#4
My Feedback: (27)
Joined: Mar 2004
Posts: 1,450
Likes: 0
Received 0 Likes
on
0 Posts
From: Woodland,
CA
RE: conversion of a 1.60fx
FAI fuel is fuel with out Nitromethane.
The link worked yesterday, I checked it.
www.rcuniverse.com/forum/fb.asp?m=7396595
Try this link and start at the top of the page.
The link worked yesterday, I checked it.
www.rcuniverse.com/forum/fb.asp?m=7396595
Try this link and start at the top of the page.
04-22-2008 | 05:59 PM
#5
My Feedback: (49)
Joined: Oct 2002
Posts: 1,158
Likes: 0
Received 0 Likes
on
0 Posts
From: Superior,
AZ
RE: conversion of a 1.60fx
http://www.rcuniverse.com/forum/m_6165393/tm.htm
Go look at this one also.This one converts a GMS 120 to gas.
Go look at this one also.This one converts a GMS 120 to gas.
