specs for current draw on servos
06-24-2006 | 07:54 PM
#1
Thread Starter
Senior Member
Joined: Nov 2002
Posts: 2,981
Likes: 0
Received 0 Likes
on
0 Posts
From: RCHill,
NJ
specs for current draw on servos
Just wanted to know what the current draw specs were for you standard s3003 servos and why this important fact isn't listed anywhere. thanks.
06-27-2006 | 08:13 AM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: specs for current draw on servos
Hi RC-FIEND,
The servo current drain depends on the load but under normal servo operation a servo will draw between 1 and 2 amps when stalled. At idle it will draw about 15 milliamps.
I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.
Sincerely,
Krysta Hunt
Lead Futaba Customer Service and Programming Technician
Futaba Service Center USA
The servo current drain depends on the load but under normal servo operation a servo will draw between 1 and 2 amps when stalled. At idle it will draw about 15 milliamps.
I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.
Sincerely,
Krysta Hunt
Lead Futaba Customer Service and Programming Technician
Futaba Service Center USA
ORIGINAL: RC-FIEND
Just wanted to know what the current draw specs were for you standard s3003 servos and why this important fact isn't listed anywhere. thanks.
Just wanted to know what the current draw specs were for you standard s3003 servos and why this important fact isn't listed anywhere. thanks.
