Controller Setup for 3d Helicopter
04-09-2006, 02:22 PM
#2
Senior Member
Join Date: Jun 2004
Location: TorreviejaAlicante, SPAIN
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
RE: Controller Setup for 3d Helicopter
Ye, real simple
set it up the same as for a plane, and add the autorotation switch to the mix.
You dont need to have the tx on heli, or any mixes
Regards
Martin
set it up the same as for a plane, and add the autorotation switch to the mix.
You dont need to have the tx on heli, or any mixes
Regards
Martin
04-10-2006, 07:18 AM
#3
Senior Member
Thread Starter
My Feedback: (4)
Join Date: May 2003
Location: Panama,
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
RE: Controller Setup for 3d Helicopter
Thx Martin.
Not sure I understand your instruction. How do you add the autorotation mix to the controller adjstments properties?
thx
Not sure I understand your instruction. How do you add the autorotation mix to the controller adjstments properties?
thx
04-10-2006, 12:26 PM
#4
Senior Member
Join Date: Jun 2004
Location: TorreviejaAlicante, SPAIN
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
RE: Controller Setup for 3d Helicopter
Hi
Have you managed to get the controler working? working on a plane?
Once you have calibrated, go to controls, double click on the one you are using, and look for auto-rotation, if you have a tx with more than 4 channels, move the button on and off that you want autorotation on, and put the dot in line with the red bar that moves when you do that and also in line with autorotation.
if you have a 4 channel tx, you will have to use a number on the key board in stead of a switch
there you go
regards
Martn
Have you managed to get the controler working? working on a plane?
Once you have calibrated, go to controls, double click on the one you are using, and look for auto-rotation, if you have a tx with more than 4 channels, move the button on and off that you want autorotation on, and put the dot in line with the red bar that moves when you do that and also in line with autorotation.
if you have a 4 channel tx, you will have to use a number on the key board in stead of a switch
there you go
regards
Martn
