I was not sure where to post this but here it is: I am in need of the engine mount
beams that come with the CG Anniversary Cub Kit I've looked all over and can't find
them.

Great Planes bought out Carl Goldberg, so they would likely be a parts resource for the Cub. Good Luck, Dave

look in the RCU market i saw a couple of CG anniversary edition kits out there and were fairly in expensive.

I had the same idea dave, I contacted them and they said
they needed a part number but there is no part number on
the original mounts or on the parts listing of the plans that
came with the kit.

Here is a link to the mount on Tower's site.
[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHBR4&P=SM]Goldberg Engine Mount[/link]

The original had aluminum mounts. I have a set of nylon beam mounts that might be a replacement for the aluminum mounts that come with the kit. Let me know what the distance is between the mounting holes on the firewall and I can measure these. Thanks Dave

Dave, the mounting holes are 19/16 center to center and the usable
beam length is 2 13/16 long Thanks Dave.

Dave that first dimension looked confusing It's 1 and 9/16 center to center.

I have a set of nylon beam mounts that measure 1 and 5/8 inches center to center and they are 3 inches long. I was cleaning up and found a set of aluminum mounts that are 2 and 1/16 inch center to center and they are about 2 inches long with 1 and 3/4 inches of usable flat surface. The mounting beam on the aluminum is off set from center. Let me know if these will work and I can send them to you. Dave

Here is a picture of the 2 of them. Let me know.... Dave

I built 3 Goldberg Cubs and they all came with the nylon mounts.

DAVE the nylon mounts sound like what I need, let me know
what you want for them/shipping I'll be thankfull. I never would
have screwed up the origonal mounts but I had a stroke a few years ago
and I'm more or less building with one hand.

Email me an address and I will get them out to you. Dave