MVVS.91 Break-in Prop/Final Prop
05-03-2005 | 10:32 AM
#1
Thread Starter
Joined: Jun 2003
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
From: New Maryland ,
NB, CANADA
MVVS.91 Break-in Prop/Final Prop
I have just purchased an MVVS .91 
I plan on following the break-in procedure as outlined by Dar Zeelon in the post Breaking in the MVVS .49 unless there is something I should do different with the .91. I am requesting information on the size and pitch of prop I should use for the break-in period and also what prop to use on my plane. My plane is a 66" Vector Flight Edge 540 should weight 8-8.5 lbs finished.
Thanks for the information.
Cata
I plan on following the break-in procedure as outlined by Dar Zeelon in the post Breaking in the MVVS .49 unless there is something I should do different with the .91. I am requesting information on the size and pitch of prop I should use for the break-in period and also what prop to use on my plane. My plane is a 66" Vector Flight Edge 540 should weight 8-8.5 lbs finished. Thanks for the information.
Cata
05-03-2005 | 01:21 PM
#3
Senior Member
RE: MVVS.91 Break-in Prop/Final Prop
Charles,
I stand by PĂ© in his general use prop recommendations.
For break-in, however, I would prefer a smaller, higher pitch prop.
I use 12.5x8 Bolly Clubman for this engine, but any 13x8 would be fine too.
It will carry your model with authority.
I stand by PĂ© in his general use prop recommendations.
For break-in, however, I would prefer a smaller, higher pitch prop.
I use 12.5x8 Bolly Clubman for this engine, but any 13x8 would be fine too.
It will carry your model with authority.
