I am in the process of build my new Knife kit and I am at the point where I need to install the pull-pull tubes in the fuse before putting on the sheeting. Does anyone have a picture of how they routed the tubes? Or tips on doing this, eg. where tubes should enter and exist.

Thanks

Northernboy,
its a little confusing if its your 1st time...it is easy..did moris include the pull pull instruction sheet? sounds like they didnt....its a little seperate instruction sheet....if not let me know and i can fax you one....just follow the instructions...you cant go wrong.....let me know


mike

I scratched my head a little too, then noticed they're right on the plan. Just put your finished framework right over the plan and make a little mark where they go.

Try this link:

Morris Knife Build

There's some pictures of the pull-pull tube installation.

Karl

I'll tell ya something else I did too. Right behind the wing at the top and bottom of the fuse I added a doubler to the main frame. Thats where it breaks at and this little doubler doesnt add much weight. I just though I would mention it since you were at the stage before sheeting................John