problem mapping with laser 6 in FMS
08-16-2005 | 10:12 AM
#1
Thread Starter
Junior Member
My Feedback: (3)
Joined: Jul 2005
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
From: Las Vegas,
NV
problem mapping with laser 6 in FMS
Hi everyone,
Not sure if this is the right spot for this but here goes. I just purchased Hitec Laser 6 Tx with cables from Tom's RC World. It came with CD so installed that along with FMS and Pre Flight. Everything looked good until I tried to calibrate the Tx. Nothing happened at all. I have installed and reinstalled software many times along with updating drivers for usb. Tx is fully charged and on.
I have XP Pro on the computer, in device manager it shows it as Human Interface Device.
Any help will be GREATLY appreciated
Thanks in advance
Not sure if this is the right spot for this but here goes. I just purchased Hitec Laser 6 Tx with cables from Tom's RC World. It came with CD so installed that along with FMS and Pre Flight. Everything looked good until I tried to calibrate the Tx. Nothing happened at all. I have installed and reinstalled software many times along with updating drivers for usb. Tx is fully charged and on.
I have XP Pro on the computer, in device manager it shows it as Human Interface Device.
Any help will be GREATLY appreciated
Thanks in advance
