Hi guys..,
i'm trying to set up the EV5U valve in mode 3 position.
First of all the plane is a Hawk.I have the additional valve that's required when using the mode 3 setup.
I'm pointing out this because that's gonna help you to understand why i'm using mode 3 on setup of valve.On this mode the rear doors close after the gear is down for landing but nothing happens after the gear is down.The doors doesn't close again.Why?
I'm trying with the card to make some combinations ,as to reverse valves or gear or the door sequence but nothing....!
What am i doing wrong guys?

Thanks in advance for any replies....

You have to plug the additional valve into the EV5U on door 2 output and program the time delay and direction for the valve through the card.

Hi Todd,
yes i did that but nothing happen for one more time. Even I plug the additional valve into the EV5U on door 3 output to see if something gonna change but nothing at all.
I don' know what other options i have to do....

Does the valve work normally using Mode 2?

Yes,the valve work normally on mode 2...

Just a thought, have you plugged the extra valve in the right way round as the jr type plug is very easy to get wrong?