Hitec Servos
05-09-2002 | 05:10 AM
#1
Thread Starter
My Feedback: (5)
Joined: Mar 2002
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
From: Fairfield, Ca
Hitec Servos
Has any one had any experience with the new digital hitec servos? Just wondering, I was thinking of putting the HS-5645mg in a hot spot any comment good, bad, indifferent, would be appreciated.
05-09-2002 | 05:58 AM
#2
My Feedback: (2)
Hitec's
Hi Jester.
I am about 3 weeks away from the maiden flight with my Hotspot
, powered by a TJT-3000. I have a pair of Hitec 5945MG's for the elevons. As I recall they were in the same ballpark as the JR 8411. This servo was a bit cheaper than the JR and it included a real nice aluminum servo arm (1 hole is threaded)
Upon comparison, the Hitec seemed to have a bit less backlash in the gear train
(both right out of the box)
Most of the remaining servos are also Hitec's, other than the Wing-Maxx's in the fins. I am running a pair of 6Volt packs with a MH voltage regulator. The gear is Robart, wheels/brakes by Trim.
We shall see...
Kelly
I am about 3 weeks away from the maiden flight with my Hotspot
, powered by a TJT-3000. I have a pair of Hitec 5945MG's for the elevons. As I recall they were in the same ballpark as the JR 8411. This servo was a bit cheaper than the JR and it included a real nice aluminum servo arm (1 hole is threaded) Upon comparison, the Hitec seemed to have a bit less backlash in the gear train
(both right out of the box) Most of the remaining servos are also Hitec's, other than the Wing-Maxx's in the fins. I am running a pair of 6Volt packs with a MH voltage regulator. The gear is Robart, wheels/brakes by Trim.
We shall see...
Kelly
Which hitecs are you using for your rudders in your hotspot?
