Any ony have a Data safe from JR and using it with a computer that has USB inputs?

I bought the adapter cable that goes from the 9 pin sierial port to the USB.
Problem is that the program is not detecting the interface because it can't find the port. It tells me to set the port manuelly.
I have tried to select the d4 different ports and the auto detect still with no results.

Any help or suggestions would be appriciated.

JR reps are you out there?

Thanks
Joe Lewis

Joe,
I went through this my self and it will not work cause your computer does not support serial ports.

You will only need to find a computer ( see if you have an old one or a desk top) and you might need an adopter for the number of pins. That is what will work. I went through that pain so I know it.
Best regards

Joe,
My computer has no serial ports. I bought a Belkin USB/Serial Adapter and have no problems with the Data Safe 2 whatsoever.
Al Watson

you have to select the correct COM port for the USB and it should work fine.

kc

Thanks for the help, I found out that I had a bad Adapter cable. I took it back to radio shack And got a new one. It works fine now