up2 / up4 question????
12-31-2007 | 08:33 PM
#1
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
From: FAIRFIELD ,
CA
up2 / up4 question????
were can i get threaded plugs for the up2 /up3 valves. i would like to cap off the unused nipples. or what size thread are the nipples and i will make my own..
thank you
Arden
thank you
Arden
01-01-2008 | 11:20 AM
#2
My Feedback: (1)
Joined: Jan 2003
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
From: Richmond, TX
RE: up2 / up4 question????
They are standard metric threads. Just locktite short metric screws in place then leak test. I have done this a few times. If you remove the nipples you will find that is how they are installed no o-rings or gaskets.
Jerry
Jerry
01-01-2008 | 12:02 PM
#4
Joined: Dec 2001
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
From: Brunswick, OH
RE: up2 / up4 question????
The threaded brass air fittings on the Ultra Precision Valves are 3mm x .5 pitch
They are not 5mm like stated above.
You can use a short 3mm cap screw or set screw to plug them off if you wish.
Darrell
They are not 5mm like stated above.
You can use a short 3mm cap screw or set screw to plug them off if you wish.
Darrell
01-03-2008 | 02:37 PM
#6
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
From: FAIRFIELD ,
CA
RE: up2 / up4 question????
the corect size is 3.5 mm i have searched the net to find the proper blanking screw . i called percission valve this am and they will ship tomorrow.
Arden
Arden
