Ok, I fixed my slipper and all that good stuff but:
Now i start the engine up and it runs fine but it cuts off at one of a few times: a) when I pull the starter. b) when i push the throttle. and 3) when I get to full throttle. and when it does stay, it goes a mere fraction of the speed it was going before I had to break it down. I changed the glow plug, its all the way on. I know one thing is that after I took my exaust off, the screws dont stay anymore I think its stripped. i was planning on taking it to my lhs but being that im only 14 and dont drive (legally) its going to be hard. So anything you guys can help me with would be great. Thanks yall

dude, i dont know what to tell ya, seems like its more of a hassle for you than anything. Two things, set your high speed needle to two turns out from bottom, and see if you can get some nuts onto those screwws if they are the ones that go to the header. other than that i would recommend you get out of nitro before you destoy your truck from frustration. or find someone close that knows nitro.

trust me ur going to get the hang of your truck u will understand it and know its limitation the needles experiment watch the DVD over and over u will get it

thanks guys,
I know it seems like a hassell but I dont mind too much. I really love rc cars and its all i want to do. I just want to get to the point where in a few years when some noob comes to me and asks me a question ,Ill be able to answer helpfully. Ive been readsing as much as I can to try and solve my problems and Its starting to pay off, I found an lhs so thats will help to.
thanksa guys