HOW DO U SET YOUR JATO 3.3 BACK TO FACTORY SETTINGS

call traxxas...i know the high speed needle is 4 turns out, but im not sure about the low speed

the low speed needle is hard to set as well as hard to get to. first clean the low speeed needle with air compresser or a toothpick. once that is clean you should be able to see a black ring on THE INSIDE of the whole component.( do not take apart the needle )the needle should be even with this small ring. for a better explanation go to traxxas.com and look at jato information

factory settings are hsn-4 turns out from closed, and lsn is screw head flush with the end of the slide(not the throttle arm)

yep the low speed needle is a pain to get to with the ez start, im putting a pull start on it to make it easier to getto

low speed needle is 1.75 turns from closed setting it flush is way too rich and is factorie settings. it took me a few days to fix it becasuse the low speed was set to high. just to let you know that it is a very rich setting i have my high speed 3 turns out and my low 1.6 it works for my needs and temp cold up hear....

thanx for all the help could i just take it down to my LHS and have them tune it or would that cost a arm and a leg.
thanx,
Corey

[>:]

you can but you will never learn how to tune the car your self that way....