usa98030

Look at this, the rod is sticking out like 1 inch and the brake and nut that it was sitting up wont match up? Do you think a tranny gear blew or something with just the rod holding the slipper clutch and stuff?

quietnas1

Wow that sucks. I couldn't tell you what happened there. I would say take the tranny apart and check the internals.

usa98030

Here i got another pic my camera died! and that was the last pic then it died. As you can tell from the pics the nut should go all the way in but the hex rod doesn't go that far! So its slightly out and won't hook on! I was gonna have a bashing party out my house for mothers day I guess ill be bashing the revo[&o] Ohh the xxxnt is a good candidate

MCSRacing

My Feedback: (2)

at a 1st guess from seeing what ya have.... i would say the spur side bearing on the slipper/brake shaft has went out and let the slipper shaft creep out some ... most likely i trashed your idler gear, the slipper shaft gear is metal ..... hope this helps!