Budd Engineering Soft Mount
05-01-2005 | 08:14 AM
#1
Thread Starter
My Feedback: (56)
Budd Engineering Soft Mount
Just noticed on Radio South's website this very nice appearing mount for many typical pattern engines. At $59.95 , it's half what I'd pay for a Hyde mount ; although they do recommend a nose ring for most applications. Curious if anyone out there is using one with an OS160 ; with or without a nose ring.
05-01-2005 | 08:31 PM
#2
My Feedback: (198)
Joined: Feb 2002
Posts: 6,707
Likes: 0
Received 0 Likes
on
0 Posts
From: El Reno, OK
RE: Budd Engineering Soft Mount
Frank, mine got here last week, and I'll be installing it shortly on my Icepoint with the OS 1.60. Already have the nose ring in there, and a Hyde mount, so I should get a good comparison. So far, I like what I see!!
05-04-2005 | 09:40 PM
#3
Junior Member
Joined: Feb 2004
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
From: Enterprise,
AL
RE: Budd Engineering Soft Mount
Frank,
I have one that I'm installing in a pattern plane with OS 1.40 RX. It is a very nice well made mount, but you MUST use a nose ring. It is not designed to be used without a nose ring.
This mount has been tested by a number of pilots for the past year or two and reports are very good.
Good Luck,
Ken B.
I have one that I'm installing in a pattern plane with OS 1.40 RX. It is a very nice well made mount, but you MUST use a nose ring. It is not designed to be used without a nose ring.
This mount has been tested by a number of pilots for the past year or two and reports are very good.
Good Luck,
Ken B.
