Clark TK22 Sound Problem
06-12-2015 | 08:51 AM
#1
Thread Starter
Junior Member
Joined: Jun 2009
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
From: Barcelona, SPAIN
Clark TK22 Sound Problem
Hello, I have installed the clark tk 22 in my HL leopard, everything works fine except for the sound it is very low. I am using a decent speaker: visaton 10W with 8 Ohms 150-20000 Hz with a 10K potenciometer however, when I use the volume knob from the HL stock electronics the sounds improves a little bit but not full potential. Any recommendations? Any advice will be appreciated
Thank you!
Thank you!
06-12-2015 | 09:03 AM
#2
Joined: Jul 2014
Posts: 267
Likes: 0
Received 0 Likes
on
0 Posts
From: Bandar Baharu, Kedah, Malaysia
I'm think you need an amp to boost the sound when using 8 ohm speaker.
Do your sound volume lower than this?
https://www.youtube.com/watch?v=y9UsVg0-gaw
Do your sound volume lower than this?
https://www.youtube.com/watch?v=y9UsVg0-gaw
06-12-2015 | 01:50 PM
#4
Joined: Jul 2014
Posts: 267
Likes: 0
Received 0 Likes
on
0 Posts
From: Bandar Baharu, Kedah, Malaysia
The speaker I'm using in that tank is 4 Ohm 10 Watts speaker & I didn't use amp. I have seen people using from 15 to 35 Watts amp. So, any amp should be good though. You may also need DC converter because all amp I have seen require 12V. There is a guy at facebook that tested many amp. If I can find which one he recommend, I'll post here.
