RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: jtisch
Showing results 1 to 25 of 500
Search took 0.75 seconds.
Forum: Kit Building
04-14-2024, 12:27 PM
Replies: 204
Views: 61,308
Posted By jtisch

Would any of you fine people have a set of the...

Would any of you fine people have a set of the Don's Custom Models 100" Super Chipmunk plans they would be willing to part with (or copy)? I picked one up yesterday but with no plans, clear canopy or...
Forum: Marketplace
10-05-2021, 10:51 AM
Replies: 1
Views: 400
Posted By jtisch

ok

ok
Forum: Marketplace
09-19-2021, 09:08 AM
Replies: 2
Views: 1,166
Posted By jtisch

I have an O.S. 120. Does that have the same...

I have an O.S. 120. Does that have the same thread as the 120 Surpass II/III ?
Forum: RC Scale Aircraft
03-14-2021, 09:02 PM
Replies: 7
Views: 4,169
Posted By jtisch

What type of DRI do you have? Is the problem only...

What type of DRI do you have? Is the problem only on take off or also landing roll out?
Forum: RC Warbirds and Warplanes
03-10-2021, 04:45 PM
Replies: 20
Views: 6,523
Posted By jtisch

Things are looking pretty good. Just have to...

Things are looking pretty good. Just have to finish the wing fillets and then final assembly can begin....
Forum: RC Warbirds and Warplanes
01-11-2021, 02:18 PM
Replies: 20
Views: 6,523
Posted By jtisch

It has almost been 4 years. Can that be true? ...

It has almost been 4 years. Can that be true? Anyway. after a bit of a break, work is contiuing.

J
Forum: RC Scale Aircraft
09-13-2020, 09:09 AM
Replies: 3
Views: 1,704
Posted By jtisch

I have purchased custom decals from Callie and...

I have purchased custom decals from Callie and have been very pleased, so I agree.

J
Forum: RC Scale Aircraft
04-30-2019, 09:07 AM
Replies: 92
Views: 49,553
Posted By jtisch

More dimension requests! can anyone tell me the...

More dimension requests! can anyone tell me the width of the fairing for the landing gear strut? The length is settled but how wide should it be at the bottom (narrower) and the top (wider) Thanks!
...
Forum: RC Scale Aircraft
04-13-2019, 11:04 AM
Replies: 92
Views: 49,553
Posted By jtisch

Does anyone have recommended control throws for...

Does anyone have recommended control throws for the elevators and ailerons? I am getting close to setting up the control surfaces. I did spend some time gluing 96 pieces of plastic triangle on the...
Forum: RC Scale Aircraft
03-30-2019, 10:14 AM
Replies: 92
Views: 49,553
Posted By jtisch

Ken, I have read of your troubles with your short...

Ken, I have read of your troubles with your short kit. I've had to/chose to make some modifications as well. The balsa leading edges on the ailerons, elevators and rudder were only wide enough to...
Forum: RC Scale Aircraft
03-22-2019, 11:01 AM
Replies: 92
Views: 49,553
Posted By jtisch

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/dscn2381_98958c86c85bc4749566a517007dc096254a1b9a.jpg

Well, it is up on its legs and all of the control surfaces are hinged....
Forum: RC Scale Aircraft
03-14-2019, 11:16 AM
Replies: 92
Views: 49,553
Posted By jtisch

Say, for this size Zlin, can anyone tell me how...

Say, for this size Zlin, can anyone tell me how far the rear of stabilizer should be from the rear of the fuselage? In other words, the stab hinge line to the rudder hinge line? The glass fuselage...
Forum: RC Scale Aircraft
03-09-2019, 09:24 AM
Replies: 92
Views: 49,553
Posted By jtisch

I also bought the tail wheel gear from Eurokit....

I also bought the tail wheel gear from Eurokit. It is a bit on the heavy side and sticks way up into the fuselage. This is a problem as I am planning keep all the controls on the inside with a single...
Forum: RC Scale Aircraft
03-07-2019, 10:51 AM
Replies: 92
Views: 49,553
Posted By jtisch

Thanks StonyZ, I have already purchased the LG...

Thanks StonyZ, I have already purchased the LG struts from Eurokit as well as the mentioned spinner. Moreover, I purchased a new canopy from the UK as the one I got was heavily scratched from sitting...
Forum: RC Scale Aircraft
02-02-2019, 10:31 AM
Replies: 92
Views: 49,553
Posted By jtisch

https://cimg4.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg4.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/dscn2373_58ab5b0e9e53738888ca682bc05ec8aa4c82523c.jpg
Well, I got the wells for the retracts and the aileron servo mostly done. I...
Forum: RC Scale Aircraft
01-05-2019, 12:08 PM
Replies: 92
Views: 49,553
Posted By jtisch

Well, I made a serious miscalculation. Using the...

Well, I made a serious miscalculation. Using the 3-view I had, I calculated the width between the the struts close enough, but I had the gear struts way too far forward. Luckily that is a much easier...
Forum: RC Scale Aircraft
12-17-2018, 02:35 PM
Replies: 92
Views: 49,553
Posted By jtisch

Thanks for the information! I already went ahead...

Thanks for the information! I already went ahead and measured a three-view and cut out space for the retracts, but I will double check with the specs you have provided. Thanks!

J
Forum: RC Scale Aircraft
11-15-2018, 10:04 AM
Replies: 92
Views: 49,553
Posted By jtisch

My Zlin has no plans and there are no markings...

My Zlin has no plans and there are no markings and there are no markings or cut outs in the wings. If someone out there has 1/5th scale plans could you tell me the distance between the wing...
Forum: RC Scale Aircraft
11-11-2018, 01:57 PM
Replies: 92
Views: 49,553
Posted By jtisch

https://cimg9.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg9.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/1024x768/lots_o_planes_045_e9060a896a9a57d9ea7d97bf1035d1ecad83d410.jpg

Here is what it looks like.
Forum: RC Scale Aircraft
11-11-2018, 10:47 AM
Replies: 92
Views: 49,553
Posted By jtisch

I picked up a Zlin 526 yesterday for an amazingly...

I picked up a Zlin 526 yesterday for an amazingly cheap price. It has a white gel coated fiberglass fuselage and and sheeted foam wing and tail. Wingspan is @83" Anyone know who the maker of this kit...
Forum: RC Scale Aircraft
09-04-2018, 10:53 AM
Replies: 26
Views: 8,157
Posted By jtisch

Would love to see one on floats!

Would love to see one on floats!
Forum: RC Scale Aircraft
05-13-2018, 08:50 AM
Replies: 97
Views: 28,002
Posted By jtisch

Vogel605, is that a Halberstadt I see up in the...

Vogel605, is that a Halberstadt I see up in the rafters? (post 28).
Forum: Engine Conversions
02-11-2018, 01:03 PM
Replies: 10
Views: 2,718
Posted By jtisch

Very nice! What are you using for a muffler? ...

Very nice! What are you using for a muffler?

J
Forum: RC Scale Aircraft
08-09-2017, 08:51 AM
Replies: 6
Views: 843
Posted By jtisch

I haven't broken the rudder or any props. My...

I haven't broken the rudder or any props. My suspicion is that with the small scale rudder, ( most other DRIs have an enlarged rudder) once the tail goes down you lose rudder control and the plane...
Forum: RC Scale Aircraft
08-06-2017, 10:10 AM
Replies: 6
Views: 843
Posted By jtisch

It takes off, flies and lands great, but on roll...

It takes off, flies and lands great, but on roll out it will nose over, especially on grass. The kit isn't cheap, but is a great value. It has a lot of parts but goes together without any problems I...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.