RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: sly2136
Showing results 1 to 25 of 223
Search took 0.57 seconds.
Forum: RC Nitro Stadium Trucks
04-11-2009, 09:41 AM
Replies: 19
Views: 1,172
Posted By sly2136

RE: What Motor to get for GT2 for Track use?

I would recommend jammin .12. Its under 100 bucks and really nice engine. rpm's makes the mph not h.p. people really over look that in rc's. no point in have 3 h.p. and only reving 28,000 rpm when...
Forum: Traxxas Monster Truck forum
03-06-2008, 01:01 PM
Replies: 40
Views: 12,561
Posted By sly2136

RE: Revo Big Block Conversion HELP!

I used the new era one with a hyper .21 8 port and everything works great, still have pullstart on with no probs.
Forum: RC Rock Crawlers
01-24-2008, 11:37 AM
Replies: 15
Views: 1,419
Posted By sly2136

RE: torque roll

what I did on mine to eliminate the torque twist all together is I mounted my 2 upper links down in the same location as my lower links on front and rear. you may need to make up some new links to...
Forum: Traxxas Monster Truck forum
07-25-2007, 09:38 AM
Replies: 12
Views: 1,826
Posted By sly2136

RE: Can Revo be competative in truggy class?

I have a modded revo with a .21 and I race it at 3 or 4 different tracks and I also own ofna truggy that we race. and the revo as of past two race events has broke and set new track records on 3...
Forum: RC Rock Crawlers
02-23-2007, 09:13 AM
Replies: 5
Views: 1,450
Posted By sly2136

RE: gmade spider

I have a gmade spider its a good rig great articulation and its tough. I agree with some people that its not the best competition rig but for what you say your gonna be doing with it, it will more...
Forum: Traxxas Monster Truck forum
02-13-2007, 01:40 PM
Replies: 6
Views: 871
Posted By sly2136

RE: Revo 3.3 running strange

I'm not saying its impossible but its not right. a properly tuned nitro engine isn't suppose to idle forever if it does its to lean. and if your running the low speed setting that lean it will run...
Forum: Traxxas Monster Truck forum
02-13-2007, 12:10 PM
Replies: 6
Views: 871
Posted By sly2136

RE: Revo 3.3 running strange

when you say it won't idle for a minute how long are you saying a real minute or 30 to 40 seconds. these motor aren't ment to idle for a very long time when tuned right they should idle for 20 to...
Forum: Traxxas Monster Truck forum
02-13-2007, 11:33 AM
Replies: 6
Views: 551
Posted By sly2136

RE: Revo 2.5R tranny question

while your in the tranny look for bearings that have failed that may have caused the tranny gears to strip. usually when a gear strips there is a cause so look closely.
Forum: Traxxas Monster Truck forum
02-13-2007, 10:49 AM
Replies: 2,573
Views: 343,437
Posted By sly2136

RE: REVO PICS(POST YOUR REVO PICS HERE)

here are some pics of my revo 3.3 with a .21 coversion and all the hop ups
Forum: RC Truggy
02-13-2007, 08:26 AM
Replies: 7
Views: 1,528
Posted By sly2136

RE: truggy wings

Another little tip that would work well with the wings is mounting your body as low as possible exposing as much of the wing as possible allowing it to work more. this is why you see more of a...
Forum: RC 1/8th Scale Buggies
01-31-2007, 03:29 PM
Replies: 61
Views: 4,347
Posted By sly2136

RE: Hyper .21 8 port engine ? c'mon lets hear it!

I have two of the .21 8 port purple head ones and they are really nice. no issues at all with them. they get between 7 1/2 minutes to 9 depending on the size of the track and the tune.
Forum: RC Truggy
01-30-2007, 01:50 PM
Replies: 2
Views: 923
Posted By sly2136

RE: Truggy body dimensions?

I have a proline crowd pleaser body for my truggy for the kyosho str and across the hood outside fender to outside fender is 6 1/2. the width across the bed is around 7 and the cut outs for the...
Forum: Traxxas Monster Truck forum
01-29-2007, 11:08 AM
Replies: 15
Views: 1,065
Posted By sly2136

RE: T-Maxx VS. REVO 3.3

it really comes down to personal preference both trucks are great really for what you want. but the biggest complaint i hear people say about the revo when bashing is the suspension is to soft for...
Forum: Traxxas Monster Truck forum
01-20-2007, 08:52 AM
Replies: 5
Views: 3,163
Posted By sly2136

RE: CLUTCH BELLS FOR REVO BIG BLOCK CONVERSION?

I use the new era conversion its an 1/8th scale clutch and flywheel combo. Fits great and works awesome. I use 18 tooth clutch bell with 36 spur. That gives me a good balance of lowend and great...
Forum: Traxxas Monster Truck forum
11-04-2006, 06:08 PM
Replies: 18
Views: 1,357
Posted By sly2136

RE: problems shifting into second with revo

turning the shift point adjustment in actually a later shift turn it back a 1/4 of a turn at a time till it shifts then you can fine tune it once it gets shifting again. also check your slipper...
Forum: RC 1/8th Scale Buggies
08-07-2006, 11:32 AM
Replies: 64
Views: 33,904
Posted By sly2136

RE: Hyper 21 8 port...good engine?

we have a new hyper 8 with a hyper .21 8port engine and the thing runs great. break in was a little finiky as most engines are but after break in just set it and for get it type of tune. i set the...
Forum: RC 1/8th Scale Buggies
08-01-2006, 02:24 PM
Replies: 15
Views: 1,137
Posted By sly2136

RE: im switching from pull start to starter box and dont have a rear cover what can i do....???

you will get grime around the shaft if you run it exposed. and you won't get the benefits of the bump starter if you leave it in the motor will still need to turn the shaft defeating the purpose. ...
Forum: RC 1/8th Scale Buggies
08-01-2006, 01:13 PM
Replies: 4
Views: 430
Posted By sly2136

RE: best glow plug for lx comp

oddonel 99
Forum: RC 1/8th Scale Buggies
08-01-2006, 01:12 PM
Replies: 1
Views: 393
Posted By sly2136

RE: how long do the ofna blue clutch shoes last?

wow this is a tuff question. allot of factors lay in on this how much you use it, high traction or low traction surface, constant on throttle or on and off throttle and how much power your putting...
Forum: RC 1/8th Scale Buggies
08-01-2006, 01:04 PM
Replies: 10
Views: 608
Posted By sly2136

RE: welll...WHAT SHOES COMPOSITE OR OFNA BLUE....?????

if it was me i would go with composite they last a real long time with minimal work. and if you notice allot of the pro drivers are softening up the engagement by mixing different spring tension on...
Forum: RC 1/8th Scale Buggies
08-01-2006, 12:04 PM
Replies: 10
Views: 608
Posted By sly2136

RE: welll...WHAT SHOES COMPOSITE OR OFNA BLUE....?????

depends are you the occasional racer that runs during the week as well. or is this a race only car. if its a multipurpose type i would go with composite its allot less maintenance. if your a race...
Forum: RC 1/8th Scale Buggies
07-29-2006, 08:21 PM
Replies: 14
Views: 998
Posted By sly2136

RE: Ofna Techs Needed !

check the screws in your drive cups on front and rear diff as mentioned above and it that don't work my guess is when you put in your motor you put the clutch shoes in wrong. if there not put in...
Forum: RC 1/8th Scale Buggies
07-29-2006, 08:10 PM
Replies: 13
Views: 1,093
Posted By sly2136

RE: want to convert my Heper 7 into truggy

if you run the offset dominator wheel part number 81154 for yellow or 81155 for the white the will fit without hitting anything. no need for adapters
Forum: RC 1/8th Scale Buggies
07-28-2006, 04:14 PM
Replies: 13
Views: 1,093
Posted By sly2136

RE: want to convert my Heper 7 into truggy

k the easiest way to do it is to buy offset wheels or standard wheels whichever you prefer 17mm hex wheels like on the jammin will work fine or get ofna dominator wheels with more offset to make it...
Forum: RC 1/8th Scale Buggies
07-26-2006, 08:18 PM
Replies: 38
Views: 1,874
Posted By sly2136

RE: Hyper 8 owners

its 100 ft by 80 ft. a technical track with hard surface, no loose dirt on top with elavation changes and with some hair pin turns and sweepers
Showing results 1 to 25 of 223
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.