RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: swps
Showing results 1 to 22 of 22
Search took 0.49 seconds.
09-14-2013, 06:40 PM
Replies: 9
Views: 817
Posted By swps

So, what did you have to change to for it to...

So, what did you have to change to for it to start flame free?
08-17-2013, 04:59 AM
Replies: 9
Views: 817
Posted By swps

I flew mine twice on diesel yesterday and I still...

I flew mine twice on diesel yesterday and I still get flames for about a second or two after pre-heat, nothing big but they are still there and always have been. I'm not sure if a switch to Kero or...
08-16-2013, 01:33 PM
Replies: 9
Views: 817
Posted By swps

You know the K-60 is so new, they just might not...

You know the K-60 is so new, they just might not know any other "better" settings than the ones they have been running. Still, I've found Barry to be ultra responsive and usually answers the phone...
Forum: RC Jets
08-16-2013, 01:30 PM
Replies: 1,560
Views: 277,537
Posted By swps

I got two more flights on my Boomerang Nano...

I got two more flights on my Boomerang Nano today. It's a great flying airplane. I need to turn up the rates on the rudder, not enough rudder on high rates for knife edge. I need to check my...
08-10-2013, 01:21 PM
Replies: 14
Views: 2,006
Posted By swps

So, I posted this in the Boomerang Nano thread,...

So, I posted this in the Boomerang Nano thread, but I flew mine with K-60 today and it worked perfectly. I timed the startup on a cold engine and it was 1:24 from trim up, throttle up to stable...
Forum: RC Jets
08-10-2013, 01:12 PM
Replies: 1,560
Views: 277,537
Posted By swps

I got another flight on my Boomerang Nano this...

I got another flight on my Boomerang Nano this morning with the new K-60g installed. It was mostly re-trimming (probably from a slightly different turbine position) and different throttle...
Forum: RC Jets
08-10-2013, 12:34 PM
Replies: 2
Views: 456
Posted By swps

Perfect! Thanks!

Perfect! Thanks!
Forum: RC Jets
08-10-2013, 10:41 AM
Replies: 2
Views: 456
Posted By swps

Colorado Jets 2013?

Anyone know when Colorado Jets 2013 is going to be held or a website? Google is not much help.

TIA

Aaron
08-09-2013, 03:14 PM
Replies: 14
Views: 2,006
Posted By swps

Acceleration delay is the throttle response, so...

Acceleration delay is the throttle response, so the delay throttling up is defaulted to 7 and deceleration is at 3 and with my altitude I've had to up the value to 25 and 9. I imagine Florida is not...
08-09-2013, 02:44 PM
Replies: 14
Views: 2,006
Posted By swps

I just got my replacement K-60 from Barry and it...

I just got my replacement K-60 from Barry and it runs PERFECTLY now. It came with the preheat RPM at 10,000 and no flames like before (first one 12 ft flames, last one 1ft flames and flameouts...
Forum: RC Jets
07-31-2013, 02:47 PM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

Ok, I got two flights in today, both had flame outs about a minute and half in so dead stick landings for both. Plane flys amazing.....for the brief periods I flew it. It's not super fast but still...
Forum: RC Jets
07-31-2013, 07:42 AM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

I think the K-60 is only available as a G model, but no problem starting at all. Fired right up from the first time. Couldn't have been simpler. Issue has been when I accelerate the motor can't...
Forum: RC Jets
07-31-2013, 06:52 AM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

No maiden yesterday. I've been having flameout issues with my K-60 due to my altitude (4800 ft). I think I got them resolved (needed to slow down the acceleration) and I'm going to try again today.
Forum: RC Jets
07-29-2013, 02:18 PM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

I got rained out of my maiden flight today....:( So I'll try again tomorrow...assuming the weather cooperates. Just to make sure, 10.75 from the trailing edge for CG that specified in the manual,...
Forum: RC Jets
07-23-2013, 05:17 PM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

I went with Tam's electric retracts and they were a real drop in fit. No problems with the wheel wells. (other than the paint flaking off) The nose gear also fits perfect. To be honest I was...
Forum: RC Jets
07-23-2013, 10:44 AM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

I built mine a few weeks ago and I had read I needed to put everything as far forward as I could, still I put stuff forward but I also made good use of the space. (ie UAT in the middle, brakes and...
Forum: RC Jets
06-24-2013, 11:21 AM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

Thanks for the fast replys, I don't have to fly off grass runways, my field is a paved runway and I also fly at salt flats so nice long smooth runway there as well.

Hooker53, where did you get...
Forum: RC Jets
06-24-2013, 07:11 AM
Replies: 1,560
Views: 277,537
Posted By swps

RE: Boomerang Nano!!!

Sluggo,
What gear setup did you go with? I'm about to order one and I want to go Electric so I'm thinking Tam's or just Eflite with the wire struts.

Thanks!
04-13-2012, 06:07 AM
Replies: 5
Views: 1,683
Posted By swps

RE: tamjet 80mm fan unit

Tam makes a carbon fiber rotor as well. You can find it here.
04-13-2012, 06:03 AM
Replies: 3
Views: 1,376
Posted By swps

RE: habu 32

The manual has a setup section for a 6 channel radio. I have 2 32's, one is on a 8 channel and the other on a 6 channel. Flight wise it does not make any difference. Setup wise, it means that you...
04-13-2012, 05:56 AM
Replies: 3
Views: 1,135
Posted By swps

RE: habu 32 help

Have you flown the regular Habu? The 32 is very similar and is the easiest fiberglass jet I've ever flown. The 32 has very good low speed qualities but you need to be comfortable in how it handles,...
04-13-2012, 05:48 AM
Replies: 4
Views: 1,085
Posted By swps

RE: habu 32 rec battery

You can unplug it or get a switch, unplugging it will put stress on the connector after time. Back in the glow only days, all radios came with a switch for the NiCd battery, you can still get them. ...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.