RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: LunchBoxx
Showing results 1 to 25 of 52
Search took 0.46 seconds.
Forum: RC 1/8th Scale Buggies
11-07-2006, 09:56 AM
Replies: 4
Views: 696
Posted By LunchBoxx

RE: i want an rc buggy

If you were a hardcore carpet racer than I would go with the 1/8 th buggy. They have a lot of tunning options and after market support. In my opinion though 2wd stadium trucks are more of a challenge...
Forum: RC 1/8th Scale Buggies
11-07-2006, 09:37 AM
Replies: 4
Views: 695
Posted By LunchBoxx

RE: ANYONE RUNNING 30% IN OFNA .26

I run O'Donnell 30% without any shims and a number 5 plug and it runs great. A lot of power at under 210 degrees.
Forum: Car Nitro & Gas Engines
11-02-2006, 12:06 AM
Replies: 7
Views: 2,391
Posted By LunchBoxx

RE: Carburetor Upgrade???

I had no idea the carb was $90.00, just save a few more bucks and get a new engine. I also think hypermanns idea is good too, if the engine still runs good just get a replacement carb on e-bay.
Forum: Car Nitro & Gas Engines
10-31-2006, 09:38 AM
Replies: 7
Views: 2,391
Posted By LunchBoxx

RE: Carburetor Upgrade???

I would try to see if the 21E slide carb from the O.S. .30 VG would fit ,if it does that would be the best choice. In my opinion O.S. has some of the best carbs in the business, and it would make a...
Forum: RC Nitro Stadium Trucks
10-12-2006, 11:11 AM
Replies: 5
Views: 997
Posted By LunchBoxx

RE: O.S. .18cv-rx vs. traxxas 3.3

If you brake in the TRX 3.3 according to factory settings it will murder a O.S. CVR-X. I know because I seen both engine run in the exact same vehicle with the same tires,gearing, and pipe and...
Forum: RC Nitro Stadium Trucks
10-11-2006, 11:28 AM
Replies: 6
Views: 790
Posted By LunchBoxx

RE: What Fuel % to use in Jato

I had that engine and I would not run anything over 20% nitro.
Forum: RC Nitro Stadium Trucks
10-09-2006, 01:13 PM
Replies: 6
Views: 464
Posted By LunchBoxx

RE: is this normal?

I am not sure if this is a common problem for this vehicle. I do not own one, but I do know that I have several nitro vehicles and they will all run to the last drop of fuel in the tank even at idle.
Forum: RC On Road Nitro Cars
10-03-2006, 11:19 AM
Replies: 154
Views: 22,434
Posted By LunchBoxx

RE: 4-tec really hitting 70?

Schumacher's are over rated yeah you can go 80 mph but you need half a mile to do it. I am talking over 80 mph in 250 feet or less.
Forum: RC On Road Nitro Cars
09-26-2006, 09:42 AM
Replies: 154
Views: 22,434
Posted By LunchBoxx

RE: 4-tec really hitting 70?

And in case if you are wondering you can tell if an engine has been modified without taking the case apart, and with no visible signs on the block(the modifiers initials or trade mark).
Forum: RC On Road Nitro Cars
09-26-2006, 09:41 AM
Replies: 154
Views: 22,434
Posted By LunchBoxx

RE: 4-tec really hitting 70?

Yeah they are, trust me boys down here do not claim, they only state facts. The only way you will here someone say they have a 80mph Jato is if they have used more than one radar gun to confirm it.
Forum: Car Nitro & Gas Engines
09-25-2006, 12:59 PM
Replies: 11
Views: 680
Posted By LunchBoxx

RE: question about trx 3.3 engine

Like I said I have seen all versions of the O.S. .18 running in front of me, and I have seen both the TRX 2.5 and TRX 3.3 run and there really is no difference in power between a O.S. .18 and a TRX...
Forum: Car Nitro & Gas Engines
09-25-2006, 12:54 PM
Replies: 11
Views: 680
Posted By LunchBoxx

RE: question about trx 3.3 engine

pull start or shaft start is the only way to, the ammount of modification it would take to make the TRX 3.3 fit might actualy affect the structural integrity of the truck when it is under load.
Forum: Car Nitro & Gas Engines
09-25-2006, 11:20 AM
Replies: 11
Views: 680
Posted By LunchBoxx

RE: question about trx 3.3 engine

The TRX 3.3 is a very good engine lots of power in a .15 sized block and do not always believe the hp the ebgine manufacters advertise remeber that is their lively hood. Their job is to sell you...
Forum: RC On Road Nitro Cars
09-25-2006, 11:13 AM
Replies: 154
Views: 22,434
Posted By LunchBoxx

RE: 4-tec really hitting 70?

Did I say the 80 mph Jatos were stock 3.3 ?
Forum: Car Nitro & Gas Engines
09-22-2006, 10:22 PM
Replies: 3
Views: 378
Posted By LunchBoxx

RE: Need Help!

No matter how rich an engine is unless it is realy cold outside a nitro engine will not smoke at idle, only once you hit the throttle.
Forum: RC On Road Nitro Cars
09-22-2006, 10:17 PM
Replies: 4
Views: 351
Posted By LunchBoxx

RE: A little Engine Work

That .12 TZ with a good pipe should still give you some trouble.
Forum: RC Nitro Stadium Trucks
09-22-2006, 10:15 PM
Replies: 5
Views: 706
Posted By LunchBoxx

RE: bigger spur?

Try stock gearing first then try the different spur. There is absolutely no reason for you to run a 58 tooth spur, maybe a 18 tooth clutch bell but if you put a 58 tooth spur a nd a smaller that...
Forum: RC Nitro Stadium Trucks
09-21-2006, 11:17 AM
Replies: 8
Views: 4,655
Posted By LunchBoxx

RE: Best "street" tires and rims for Nitro Rustler

The new anacondas from traxxas on Jato rims.
Forum: Car Nitro & Gas Engines
09-21-2006, 11:15 AM
Replies: 6
Views: 703
Posted By LunchBoxx

RE: problems with picco 28 turbo

Sounds like the engine has an air leak, seal all ares were there are o-rings with a small dab of high temp automotive silicone sealer all the way arrond the o-ring and snug everything up. Let it sit...
Forum: Traxxas Monster Truck forum
09-21-2006, 11:05 AM
Replies: 5
Views: 401
Posted By LunchBoxx

RE: HELP WITH T-MAXX 2.5R GEARING

yeah it is strong enough to pull it.
Forum: Traxxas Monster Truck forum
09-20-2006, 10:25 PM
Replies: 5
Views: 401
Posted By LunchBoxx

RE: HELP WITH T-MAXX 2.5R GEARING

Stock gearing is 20 tooth clutchbell and a 72 tooth spur. With a TRX 2.5 I ran a 22 tooth clutchbell and a 70 tooth spur gear and it ran really good any more than that and you run the risk of over...
Forum: RC 1/8th Scale Buggies
09-20-2006, 02:00 PM
Replies: 21
Views: 1,290
Posted By LunchBoxx

RE: OFNA HYPER 8 PORT FOR RACING TELL ME WHAT YOU THINK............!!!!!!!!!!

I run o'donnells 30% through mine and it screams. If you start having problems with the carb just swap it for a O.S. 20E carb off of O.S. .21 RG it will be more reliable and consistent, get the tune...
Forum: Car Nitro & Gas Engines
09-20-2006, 01:27 PM
Replies: 3
Views: 524
Posted By LunchBoxx

RE: wat do hobao .21 8port wit boost run like

If you want to take care of the only problem I know of with those engine wich is they can be a bit touchy with the stock carb, replace the stock carb with a O.S. 20E carb from a O.S. .21 RG and the...
Forum: RC On Road Nitro Cars
09-20-2006, 01:09 PM
Replies: 6
Views: 706
Posted By LunchBoxx

RE: took my serpent to the track.. vid!

It looks like once you get use to driving the car a little more that thing will fly. Do you still have the video of the electric TC-3 that went 134mph?
Forum: Car Nitro & Gas Engines
09-20-2006, 11:44 AM
Replies: 20
Views: 1,355
Posted By LunchBoxx

RE: Best Engine for under $170?

If I were you I would run the O.S. VZB .21 with a Jammin JP-2 top end pipe, you should be set.
Showing results 1 to 25 of 52
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.