RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: SHREADHEAD
Showing results 1 to 25 of 40
Search took 0.42 seconds.
Forum: RC Truggy
06-23-2007, 07:39 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Sorry no rev for me perhaps when we get back from the nats.
Forum: RC Truggy
06-19-2007, 07:29 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

I do believe thats the jammin body and notice how the wheel wells don't fit the wheel base.
The problem that the mugan body solves is the dirt factor. The reason I went to a single body mount
in...
Forum: RC Truggy
06-19-2007, 08:33 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

MBX5 crowd pleaser use front hole setback then move them in 4mm on eachside i believe. This body is the best I have found and I
have tried k, jammin, thunder tiger, REVO, HOT BODY's, all used of...
Forum: RC Truggy
06-06-2007, 12:25 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Nice I'm glad, those are just the general.
Tuneing is the joy for me and the nightmare at the same time.[:@]
I always am looking for more and yes it comes down to driving when she is close.
Forum: RC Truggy
06-04-2007, 06:15 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Genarely when an engine goes from fine to overheat or flat or slow it is
something else other then the motor
Forum: RC Truggy
06-01-2007, 08:10 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

For handling try to run the arms above level for more off power push run the rear bones level.
limit the down travel or what some call droop, to your liking, very little at a time
I go with 2...
Forum: RC Truggy
06-01-2007, 07:34 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Put fuel in the tank plug pressure nipple then suck on a "LONG" piece of
fuel line and look for bubbles. When you tip a car forward the inner tank nipple goes to dry
considering its in the back...
Forum: RC Truggy
05-14-2007, 10:53 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

check that the mid is flush and points to the hsn that's the good spot and set the
hsn & lsn were it runs well and tune 1 to 2 hour adjustments at a time.
It takes about 10 to 15 tanks for that...
Forum: RC Truggy
05-14-2007, 04:21 PM
Forum: RC Truggy
05-13-2007, 09:33 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Mugan mbx5 body works well and is longer in the wheel base so that
helps keep it clean on the inside. use the stock front hole dents in the lexan
just come in 4mm on each side. only use one body...
Forum: RC Truggy
05-10-2007, 07:17 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

YEP nice choice any questions or when your runnin just holler.
put my ST-1 in the expert A main at rev sat. night, while braking in a new motor :D
Forum: RC Truggy
05-10-2007, 12:46 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

The tech support is good as well:D
Forum: RC Truggy
05-09-2007, 08:53 AM
Forum: RC Truggy
05-08-2007, 09:18 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Hey now little trooper slow down
lets start with your nitro experience:D
Forum: RC Truggy
05-08-2007, 12:30 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

TRuggy's can always use good servos the tires are big.
Remember setup is always a must for drivers style and
learning how to is half the fun
Forum: RC Truggy
05-07-2007, 10:53 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

There is not one out yet for the ST-1 but they do have one for the
center diff.
The turning issues are that of the end points or not turning sharp enough
Forum: RC Truggy
05-02-2007, 11:22 PM
Forum: RC Truggy
05-02-2007, 07:58 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

I believe the third needle you might be seeing would be the idle screw.
Be sure not to turn IN any screws before applying throttle. this includes idle
and low end. I first set the idle with a 1mm...
Forum: RC Truggy
05-01-2007, 07:55 PM
Forum: RC Truggy
04-30-2007, 07:55 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

SORRY !! didn't check forum till monday but ya herd the had a bobcat there this
weekend. Perhaps a new track is in order.
Forum: RC Truggy
04-28-2007, 01:07 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Nice job on the mud guards.
Don't have an address but try this for directions
91 to 55 to 22 towards Long Beach exit harbor go left to Edinger go left go over river track
will be on left across...
Forum: RC Truggy
04-27-2007, 09:41 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Not like some of your bigger crowded tracks but the track ripps and the people are cool
Forum: RC Truggy
04-26-2007, 08:51 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

So your sayin rev. sat. and the box on sunday
Forum: RC Truggy
04-26-2007, 12:32 AM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

That would be in the choice off shock oil thicker , less dampening
Forum: RC Truggy
04-19-2007, 06:53 PM
Replies: 741
Views: 66,458
Posted By SHREADHEAD

RE: ]ยง[ Official Team VTX ST1 Thread ]ยง[

Oh yes these truggy's are hard on servos so get a good one set the servo saver and she will last.
give me a shout when your heading to the track
Showing results 1 to 25 of 40
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.