RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: RipFree
Showing results 1 to 20 of 20
Search took 0.33 seconds.
01-21-2008, 12:39 PM
Replies: 2
Views: 931
Posted By RipFree

RE: NEED HELP URGENTLY!

Yes, but i found the problem. I'm sorry, i always post ahead of time just in case it all goes wrong. The 9 pin connection between the yaw gyro and the circuit board is loose. Need to resolder. Sorry,...
01-20-2008, 12:42 PM
Replies: 2
Views: 931
Posted By RipFree

NEED HELP URGENTLY!

My DF5 has been acting very wierd. The motors keep spasming which makes the Df very hard to fly. Also, it continuously yaws to the left. I thought that maybe one of the motors' capacitors had gone,...
01-14-2008, 11:49 AM
Replies: 3
Views: 1,617
Posted By RipFree

RE: Cheap home made SAVS alternative.

Well, previously on my camera, there had been a noticeable amount of shaking when the DF reached higher altitudes. I am trying to correct this and hopefully i will see improvements to my flight...
01-13-2008, 09:31 AM
Replies: 0
Views: 752
Posted By RipFree

Camera-surging problem

The problem was that the transmitter's battery was low.
01-12-2008, 04:31 PM
Replies: 3
Views: 1,617
Posted By RipFree

Cheap home made SAVS alternative.

Hi, i'm currently working on a little pet project which is to make an SAVS type camera mount out of recycled draganflyer pieces and common household items (because nobody wants to spend $1000 on an...
01-12-2008, 01:42 PM
Replies: 2
Views: 1,123
Posted By RipFree

RE: Trying to decide on a RC Helicopter

Well, some of the reasons i like the DF are; the manuverability of it. Four motors give it alot of thrust for an electric heli and makes it feel truly manageable. One of my buddies has a heli (a...
01-07-2008, 03:16 AM
Replies: 2
Views: 993
Posted By RipFree

RE: dragonflyer 5 ti my questions

They didn't make it clear in the manual.

2)you land it and press the arming button while it is still armed holding the rudder full left and down.

3) Basically, the switch and startup...
01-02-2008, 03:12 AM
Replies: 7
Views: 1,551
Posted By RipFree

RE: Portable recording?

Thanks FL_P*I*, but i need something that's a bit cheaper.
01-01-2008, 11:07 AM
Replies: 7
Views: 1,551
Posted By RipFree

RE: Portable recording?

The finepix? No, i have the normal eyepiece on my DF.
01-01-2008, 10:04 AM
Replies: 7
Views: 1,551
Posted By RipFree

Portable recording?

Hi, i need a portable recording station for use with my DF to help out my friend's construction work. I've tried to use a finepix camera but it won't record feed from an external RCA source (the DF's...
01-01-2008, 06:21 AM
Replies: 11
Views: 2,931
Posted By RipFree

RE: earial video plaform

Well, no it wasn't at that high an altitude, probably around 40ft.

And also, no i didn't measure it, but i'm pretty sure some of the gusts were around 30 mph (they blew me). The sustained wind...
12-31-2007, 05:40 AM
Replies: 3
Views: 1,658
Posted By RipFree

RE: Draganflyer replacement motors?

Yes it is the mabuchi 380, but which model is it? The RA or SA
12-31-2007, 02:53 AM
Replies: 11
Views: 2,931
Posted By RipFree

RE: earial video plaform

The reason people don't like the savs is because it is so expensive compaired to the DF 5 for little change ($1000 or so) in flight performance. But the camera is superior to the DF 5's so you might...
12-30-2007, 12:27 PM
Replies: 14
Views: 2,552
Posted By RipFree

RE: A few draganflyer 5 questions...

Or you could forget about this and go down to the pub for a beer :D.
12-30-2007, 11:13 AM
Replies: 14
Views: 2,552
Posted By RipFree

RE: A few draganflyer 5 questions...

Oh yes, sorry FL_PL, I replied before you put up the picture, or maybe my computer didn't load it in time. That is an excellent idea, but i agree with mike, they will get blown around a bit. Here's...
12-30-2007, 10:12 AM
Replies: 3
Views: 1,658
Posted By RipFree

Draganflyer replacement motors?

Where can i buy cheap replacement DF motors? Amazon sells them for around $13 per motor. I figure that there must be cheaper alternatives.

Thank you very much.
12-30-2007, 02:15 AM
Replies: 14
Views: 2,552
Posted By RipFree

RE: A few draganflyer 5 questions...

Hey FL_PL,

Your way of keeping orientation is a great idea, but your just a bit late as just yesterday i was looking over mike's brushless conversion slideshow and i saw that he had put bits of...
12-29-2007, 07:35 AM
Replies: 0
Views: 708
Posted By RipFree

Psychic?

I was flying my draganflyer outside, normal, very windy day. I brought it down and suddently thought of how i hadn't set the autoland feature. I set it and flew it up again. A few minutes in, the...
12-28-2007, 04:14 AM
Replies: 14
Views: 2,552
Posted By RipFree

RE: A few draganflyer 5 questions...

Good idea about the cellophane tape, but i will have to do some research (most coloured tape i find is quite heavy). I belive have already pushed the cf tubes as far as i can into the base, but i...
12-27-2007, 02:32 PM
Replies: 14
Views: 2,552
Posted By RipFree

A few draganflyer 5 questions...

So i got the draganflyer for christmas:D, and i'm a pretty good pilot as i have had experience with other rc helis. Now, i have the draganflyer 4's camera and i attached it to the new draganflyer. My...
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.