RCU Forums - Search Results

Search: Posts Made By: altidsulten

Showing results 1 to 8 of 8
Search took 0.08 seconds.

Forum: 3D Flying!

03-13-2008, 09:12 AM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Congratulations Aandreas!
Looks good too!

Thomas Pedersen

Forum: 3D Flying!

02-14-2008, 02:29 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi,
Finally the weather was fine this tuesday! It flew perfect!!
I had the CG about 1 cm in front of what was recommended in the instructions and it needed a couple of up trim and a few right...

Forum: 3D Flying!

12-30-2007, 02:37 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi,
Inspirred by Georgee, I made some decoration on both wing and fuselage.

Regards
Thomas Pedersen

Forum: 3D Flying!

12-27-2007, 04:29 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi Georgee,
VERY nice looking bird you got there!!
Is it posible to buy at set too? I might be interrested.
Yes, the Moki is a nice engine, I have flown it in a CMPro Giles 202 (6,3kg) and it...

Forum: 3D Flying!

12-20-2007, 04:35 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi,
Georgee: Good luck, please report back how it went!

I have been on hold on this one, because I have been waiting for my silencer. I ordered a custombuild from justengines and have just...

Forum: 3D Flying!

11-22-2007, 03:25 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi Zippi,
Works fine for me, just checked.
www.peakmodel.com

Regards
Thomas Pedersen
Denmark

Forum: 3D Flying!

11-07-2007, 01:41 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Hi aandreas,
I have used a receiver without PCM in a CMPro Giles 202 140 with a Moki 180 gasser without any problems (aprox 30 cm between receiver and any of the engine electronics), BUT i will buy...

Forum: 3D Flying!

11-05-2007, 12:53 PM

Replies: 420

Peakmodel Extra 260 25%

Views: 85,764

Posted By altidsulten

RE: Peakmodel Extra 260 25%

Georgee:
I would be very interrested in hearing how it goes with that engine and where your all up weight ends!!! I have the same engine and I am considering either the Su-26, Yak-54, Edge 540T or...

Showing results 1 to 8 of 8