EZ Start insulator wearing off
#1
Senior Member
Thread Starter
Join Date: Nov 2007
Location: Brookfield, WI
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
EZ Start insulator wearing off
Ive had my revo for a few days and have changed the glow plug/checked them a few times and when I do I use a needle nose pliers. After a while the insulation thing of the wire began to come off, and at the bottom it wore all the way down to the spring. Has this happened to any of you? Also, my LHS guy gave me a O.S. Plug Long Reach LC3 Hot and I tried for about an hour and it wasnt going in... anyone have any suggestions. thanks a lot
#3
Senior Member
Join Date: Dec 2007
Location: Cumberland Gap, TN
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ Start insulator wearing off
i had the same problem....i went to walmart and got some shrink wrap stuff....its this stuff you put around wires take a lighter and hold the flame to it and it shrinks to fit the wire....works perfect...u can get it to withstand the heat....better than electric tape and costed just as much as a roll of electric tape
#5
Senior Member
Join Date: Mar 2006
Location: Brantford,
ON, CANADA
Posts: 2,541
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ Start insulator wearing off
just use a regular glow ignitor...it will start easier and your battery will last longer and you don't have to worry about that wire anymore.
#7
Junior Member
Join Date: Nov 2007
Location: Lancaster, CA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
RE: EZ Start insulator wearing off
what i used to do was double layer some shrink wrap, held up great... i just got rid of my ez start today, its nice to not have to worry about your starter battery dying like mine always seemed to do on some cold days, i got a pull start off ebay for 5 bucks and a nice long reach glow starter for 20$ at my lhs.