Go Back  RCU Forums > RC Airplanes > ARF or RTF
Vector Flight Edge 540? >

Vector Flight Edge 540?

Community
Search
Notices
ARF or RTF Discuss ARF (Almost Ready to Fly) radio control airplanes here.

Vector Flight Edge 540?

Thread Tools
 
Search this Thread
 
Old 07-02-2003 | 11:18 PM
  #51  
Member
 
Joined: Feb 2003
Posts: 42
Likes: 0
Received 0 Likes on 0 Posts
From: Dublin, CA,
Default Vector Flight Edge 540?

Calflyer, can you give some numbers on reduced rates for the 66" Extra? I only have a single rate 4 channel radio for this plane and don't know what to set the throws at safely. Thanks.

~noah
Old 07-03-2003 | 01:18 AM
  #52  
Senior Member
 
Joined: Aug 2002
Posts: 310
Likes: 0
Received 0 Likes on 0 Posts
From: Anytown, CA
Default Vector Flight Edge 540?

Sydways, for initial flights I would say no more than half inch up and half inch down for the elevator and about 3/4 inch each side for the rudder. The ailerons should be about 1/2 inch also. I am trying to work this from memory as I took the radio out of the 300S for the 540. You can always increase the throws after you get used to the airplane.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.