Community
Search
Notices
E-Flite Helicopters Discuss the line of E-Flite mini and micro helis including the Blade CP, CP Pro, Blade CX, etc

vortex cx2 motors????

Thread Tools
 
Search this Thread
 
Old 02-18-2008 | 01:35 AM
  #1  
Thread Starter
Member
My Feedback: (7)
 
Joined: Jan 2008
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
From: Valleyford, WA
Default vortex cx2 motors????

hi i was flying my heli today that i got last week and notcied it has really lost alot of power so i decided my motors are going bad and i was wondering where the cheapest place to buy the vortex motors are i just need a couple replys
thanks for your times
Old 02-18-2008 | 01:52 AM
  #2  
 
Joined: Aug 2007
Posts: 6,441
Likes: 0
Received 0 Likes on 0 Posts
From: Lincoln, NE
Default RE: vortex cx2 motors????

Someone said that the vortex motors perform worse than the stock CX2 motors. Stick with the stock ones or the Xtreme motors.
Old 02-18-2008 | 02:35 AM
  #3  
Thread Starter
Member
My Feedback: (7)
 
Joined: Jan 2008
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
From: Valleyford, WA
Default RE: vortex cx2 motors????

where can i get teh xtremes ive had bad luck with the stock motors also will the heat sink work on the xtreme motors and how much do they cost moneys really tight i rolled my truck 2 days ago
Old 02-18-2008 | 03:12 AM
  #4  
Coyote64's Avatar
Senior Member
 
Joined: Dec 2007
Posts: 542
Likes: 0
Received 0 Likes on 0 Posts
From: Cleveland, UNITED KINGDOM
Default RE: vortex cx2 motors????

I used vortex motors as an upgrade and found they were no better than the cx2 stock ones so i would get the extreme 180 instead
Old 02-18-2008 | 05:10 PM
  #5  
 
Joined: Aug 2007
Posts: 6,441
Likes: 0
Received 0 Likes on 0 Posts
From: Lincoln, NE
Default RE: vortex cx2 motors????


ORIGINAL: crawlerking11

where can i get teh xtremes ive had bad luck with the stock motors also will the heat sink work on the xtreme motors and how much do they cost moneys really tight i rolled my truck 2 days ago
I and others like UShobbysupply. I use the heat sink on the motors with no problem. They are $16 a piece. You need the A and B motors. When you install them make sure the capacitors are on the outside. With carbon brushes they should last longer than the stock ones. Then you can just change out the brushes which I think are $3. http://www.ushobbysupply.com/product...roducts_id=248
Old 02-18-2008 | 05:18 PM
  #6  
Senior Member
 
Joined: Dec 2007
Posts: 301
Likes: 0
Received 0 Likes on 0 Posts
From: Rio Rancho, NM
Default RE: vortex cx2 motors????

May I also recommend BoomTown Hobbies. [link=http://shop.boomtownhobbies.com/main.sc]BoomTownHobbies[/link] Prices are good and customer service is excellent! Jamie is great answered my questions right away..
Old 02-18-2008 | 11:50 PM
  #7  
S!N!ST3R RC hObbys's Avatar
Senior Member
 
Joined: Oct 2007
Posts: 374
Likes: 0
Received 0 Likes on 0 Posts
From: Cullman, AL
Default RE: vortex cx2 motors????

Can someone post a pic of theses vortex motors iv never seen them
Old 02-19-2008 | 03:23 AM
  #8  
Coyote64's Avatar
Senior Member
 
Joined: Dec 2007
Posts: 542
Likes: 0
Received 0 Likes on 0 Posts
From: Cleveland, UNITED KINGDOM
Default RE: vortex cx2 motors????

Here you go :

Old 02-19-2008 | 08:45 AM
  #9  
Senior Member
 
Joined: Dec 2007
Posts: 139
Likes: 0
Received 0 Likes on 0 Posts
From: UK, UNITED KINGDOM
Default RE: vortex cx2 motors????

No-one has asked the question - How old is your CX2? You say you have owned it for about a week?

If so, your Motors shouldn't be defective after just this short time!
Have you checked all the usual places for Binding, that could be causing loss of power?

I recently experienced reduced flight times, and blamed either the Motors or Batteries!
Turned out the Outer Shaft was bent, causing binding also on the inner shaft, and draining the battery in no time!

Worth the inspection, and could save you some $$ !
Anyhow, I'd recommend the Xtreme 180 motors if you do decide to "upgrade".

Cheers.
Old 02-19-2008 | 11:17 AM
  #10  
S!N!ST3R RC hObbys's Avatar
Senior Member
 
Joined: Oct 2007
Posts: 374
Likes: 0
Received 0 Likes on 0 Posts
From: Cullman, AL
Default RE: vortex cx2 motors????

Ok got ya, have yall seen the new motors out, I found these at cx2parts.com or somthing, they look like the xtreme 180 but diffrent stickers and brand...

<a href="http://s212.photobucket.com/albums/cc151/SickRCboats/?action=view&current=01IMG_5910.gif" target="_blank"><img src="http://i212.photobucket.com/albums/cc151/SickRCboats/01IMG_5910.gif" border="0" alt="Photobucket"></a>



Are these good motors?




Old 02-19-2008 | 02:18 PM
  #11  
eat2muchrice's Avatar
Senior Member
 
Joined: Nov 2007
Posts: 864
Likes: 0
Received 0 Likes on 0 Posts
From: Novato, CA
Default RE: vortex cx2 motors????


ORIGINAL: H3li

No-one has asked the question - How old is your CX2? You say you have owned it for about a week?

If so, your Motors shouldn't be defective after just this short time!
Have you checked all the usual places for Binding, that could be causing loss of power?

I recently experienced reduced flight times, and blamed either the Motors or Batteries!
Turned out the Outer Shaft was bent, causing binding also on the inner shaft, and draining the battery in no time!

Worth the inspection, and could save you some $$ !
Anyhow, I'd recommend the Xtreme 180 motors if you do decide to "upgrade".

Cheers.

yes, its not your motors. Last thing you should check would be them.
1. Check Blades.
2. Check shafts.
3. Gearmesh.
4. bearings.
5. Then motors.
6. Test 3-1.

All the how to info is in here.
Tips/Repair/Guides/Mods Links
http://www.rcuniverse.com/forum/m_70...tm.htm#7035042

Old 02-20-2008 | 09:13 PM
  #12  
Member
 
Joined: May 2007
Posts: 64
Likes: 0
Received 0 Likes on 0 Posts
From: Southfield, MI
Default RE: vortex cx2 motors????

I too have had my CX2 for about 6 days nw and right out of the box my father in laws $70 Happy time hobbies Huey makes this thing look really bad....I've check and rechecked everything but the 3-n-1...hopefully when I return it tomorrow I get a nice new one
Old 02-27-2008 | 07:52 PM
  #13  
Thread Starter
Member
My Feedback: (7)
 
Joined: Jan 2008
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
From: Valleyford, WA
Default RE: vortex cx2 motors????

i forgot to say that my cx2 ips used i bought it used here in the callsifeieds the guy had no clue they were going bad cuz i didnt even notice it the first couple times i flew
i no its the motors because i have inspected everything and put in my buddies stock motors and it took right off but i had to give them back to him the next day

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.